Punching "sub" followed by "2.0" or "2.4" should also restore
signal. The wide or narrow filter is selectable independent
of the operating mode on the sub-receiver.
73,
... Joe, K4IK
> -----Original Message-----
> From: yaesu-admin@contesting.com [mailto:yaesu-admin@contesting.com]On
> Behalf Of k3ky@erols.com
> Sent: Friday, March 08, 2002 1:47 AM
> To: Barry Kirkwood; yaesu@contesting.com
> Subject: Re: [Yaesu] FT1000D question
>
>
> Hi, Barry-
> Whenever it 'goes dead' in CW mode, all you need to do is to
> punch SUB (on the numeric keypad) followed by USB from the
> bank of mode switches. Your sub-rx will spring back to life.
> 73, David K3KY
>
> On 8 Mar 2002 at 0:45, Barry Kirkwood wrote:
>
> > My new (to me) FT1000D sub receiver goes deaf when I switch to narrow
> > cw receive. Apparently one is meant to fit a narrow 455 filter in the
> > subrx to listen in this mode. I could live with subrx in SSB bandwidth
> > while main rx in narrow mode. Does anyone know of a fix that would
> > keep the 455 subrx SSB filter in the line at all times? 73
> >
> > end
> > Barry Kirkwood PhD ZL1DD
> > Signal Hill Homestay
> > 66 Cory Road
> > Palm Beach
> > Waiheke Island 1240
> > NEW ZEALAND
> > www.waiheke.co.nz/signal.htm
> >
> >
> > _______________________________________________
> > Yaesu mailing list
> > Yaesu@contesting.com
> > http://lists.contesting.com/mailman/listinfo/yaesu
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
>
|