Thanks for this list! I have often read excerpts from the archives over the years. I am in the process of combining a pair of eight 2SC2879 KW amps for 160-10M and need some help as I make this work.
If it Hertz enough it makes you psycho ... like the dental work I had just before Christmas! ... ;-} wb8jkr@juno.com wrote: Naw, a Hertz is a cycle. Mark WB8JKR I thought a Hertz was a dipole... -- T
I am combining a pair of eight 2SC2879 KW amps for 160-10M and need to acquire a Splitter & a Combiner. RF Parts www.rfparts.com/combiner.html appears to have the splitter and combiner I need. I will
Anyone used the LDG AT-1000? What is its true power-handling capacity? Does it "melt" with too much input power (after tuning, as I know the tuning stage is power-protected), does it shut-down with t
I need to access the gathered wisdom here ... I am building a switched low pass filter for my full legal 160-10M solid state amp (1500W). I have access to a number of free (from a friend) older surpl
Thanks! Yours, and a private reply, both said the same thing and the last bit about the "small 1KV air variables may be paralleled with the micas. The ARCO 500V mica padders will also survive in this
Dan Levin wrote: I have (once again) become enamored with the idea of designing (and building, I hope) a solid state amplifier for 160 - 10 meter use. Ideally, this amplifier would deliver 1500 watts
Bill L. Fuqua wrote: I have a 2KW plasma generator that operates on 13.56MHz that has a small circuit board with only one 5763 tube oscillator driving a neutralized 5cx1500. Why not replace it with a
Is the impedance of of your antenna flat from 160-10M or does it vary from below 50 Ohms to the hundreds or perhaps 1,000's of Ohms? The Tuner will handle that but will your plate tuning circuit? Rat
Dan Levin wrote: As part of our "open source" project to create a reference design for a 1500 watt solid state amplifier ( http://www.k6if.com/ssamp/ ), we have designed a printed circuit board to im
Anyone know if the Basic Stamp module for circuit monitoring and protection used in project Gamma may be programmed from a Linux editor? http://www.parallax.com/detail.asp?product_id=27294 http://k6i
There was some recent discussion on the list re. converting illegal CB amps to legal Ham use. I am doing that but am going to start with a single amp rather than paralleling two together -- a signifi
I have been asked if the pair of Johnson 229-203 28 uH roller inductors I have posted for sale would handle an antenna tuner at 1000 watts AM from a BTA-1R2. It is my belief that except for an absurd