Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+Edge\s+wound\s+inductors\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+Edge\s+wound\s+inductors\s*$/: 6 ]

Total 6 documents matching your query.

1. [Amps] Edge wound inductors (score: 1): Author: robert briggs <vk3zl@bigpond.com>; Date: Wed, 28 Feb 2007 10:31:34 +1100; I have a quantity of these edge wound inductors ex old broadcast station equipment.Most were made by AWA. They range from quite small, 30uh to more than 300uh.I have been able to use a few of the sma; /archives//html/Amps/2007-02/msg00409.html (6,719 bytes)
2. [Amps] Edge wound inductors (score: 1): Author: Larry <larry@w7iuv.com>; Date: Tue, 27 Feb 2007 16:04:57 -0800; OK guys, help me out here. I just don't see the advantage of using these edge wound inductors. I have several and have measured their Q. The measured Q does not impress me as it was about the same as; /archives//html/Amps/2007-02/msg00410.html (7,529 bytes)
3. Re: [Amps] Edge wound inductors (score: 1): Author: Ian White GM3SEK <gm3sek@ifwtech.co.uk>; Date: Wed, 28 Feb 2007 08:36:40 +0000; Isn't it mostly about being able to make a really good sliding contact to the two flat sides? -- 73 from Ian GM3SEK _______________________________________________ Amps mailing list Amps@contesting.c; /archives//html/Amps/2007-02/msg00411.html (7,026 bytes)
4. Re: [Amps] Edge wound inductors (score: 1): Author: "Tom W8JI" <w8ji@w8ji.com>; Date: Wed, 28 Feb 2007 05:54:45 -0500; The factors that affect optimum form factor of an inductor would fill a good sized book, but the edge wound tape does two good things besides the obvious mechanical tap attachment advantage. First,; /archives//html/Amps/2007-02/msg00412.html (7,953 bytes)
5. Re: [Amps] Edge wound inductors (score: 1): Author: Larry <larry@w7iuv.com>; Date: Wed, 28 Feb 2007 08:04:22 -0800; I don't see the tap advantage. If a round conductor coil is wound and supported in a similar manner, then the same type of clamps can be used. I have some of these made for standard coils and they wo; /archives//html/Amps/2007-02/msg00414.html (10,894 bytes)
6. Re: [Amps] Edge wound inductors (score: 1): Author: garyschafer@comcast.net; Date: Wed, 28 Feb 2007 16:22:48 +0000; I assume that you are comparing an edge wound inductor height to that of a similar height round wire. By shaving off the sides of the wire to make it a flat edge wound coil wouldn't you be reducing t; /archives//html/Amps/2007-02/msg00415.html (9,374 bytes)

Current List: 1 - 6
Page: [1]