I'm trying to design a coil that will be used in a 1500 watt filter at HF. I know that I need to allow for frequency related skin effect that will reduce the area of the wire or tubing carrying the c
The theory behind this is quite involved, but is well described in Terman's "Radio Engineer's Handbook" (pp 28 - 37 in my 1943 edition). Basically you can find the RF resistance per unit length at a
The amount of heating you will see in your inductor will depend on the ratio of the loaded vs. unloaded Q of the inductor. In circuits like TVI low-pass filters, the loaded Q is very low (something l
E. F. Johnson rated its #14 gauge Cu roller coil at 3A @ 30MHz. Rich Measures, 805.386.3734, AG6K, www.somis.org _______________________________________________ Amps mailing list Amps@contesting.com
Dan, Check some of the earlier handbooks back in the 80's or 70's. They did have a table in there for frequency and power to wire size. At 30 MHz, you'll need around 3/16"-1/4" copper tubing for the
Author: "Carcia, Francis A HS" <francis.carcia@hs.utc.com>
Date: Fri, 15 Apr 2005 14:21:41 -0400
I think it was 1 KW input am modulated so close enough. Dan, Check some of the earlier handbooks back in the 80's or 70's. They did have a table in there for frequency and power to wire size. At 30 M