OK to all who are interested: And to those who were not sure. I received a response from the FQP folks. The answer was this: If you use Telnet, spotting nets, ect it is considered that you are receiv
The meter on my CDE (HamIV) Controller will only read between the N in the middle and the S on the left hand side, it will not move to the S on the right side of the meter or past the N in the middle
I downloaded the rules for the na sprint to try my hand at a sprint which I have here-to-fore not gotten involved in with contests. I noticed by listening first, that when a station CQ'd they made a
The contest is well on its way and I am enjoying it allot The question I have is has anyone noticed how out of date the website for the contest is, http://www.crk.cz/ENG/DXCONTE.HTM or is it I am on
Ok found the problem For some reason in my ie browser the rtty section doesn't show up but in my Mozilla it does, thanks for making me look further into it. Bob AD5VJ ________________________________
You could always download and install N1MM free contest logger and then perhaps import your contacts ect and it will generate a cabrillo and all the rest for you. Bob AD5VJ __________________________
Did I mis-read this? 3. Categories: Single operator or multi-operator. Remote or Cluster spotting shall not be used. All transmitting and receiving antennas used must be within 100 km of each other.
OK I guess my basic assumption was everyone was in the contest, guess we all know what you get for ass u me Hi Hi Thanks for the replies, I guess if they can get more contacts that way, more power to
I have not read this entire thread, so pls no one take any offense to what I am about to say, however, I dont understand why there would be any delay in submitting logs in the times we live in. In th
I see that as reasonable for someone in your situation what with the travel ect. Its just to those who dont have the load a station like yours would have (DX) or a work load like yours and are simply
I dont care one way or the other on the 'extreme' category. I wont be joining it anyway. I figure I can instant message if I want to go that route. What I dont understand, however, without trying to
For this weekends CQWW there is no choice for 'single-op assisted' as far as power is concerned. So I am assuming it is considered in the high power category, is that correct. Bob AD5VJ _____________
Thanks for all the help and advice over the years: Don't let anyone tell you that 30 foot of tower and a small beam cant make any difference, just DO IT. Could higher and bigger make an even bigger d
What are your opinions on shack lighting for contests? What is proven to be less tiring on the eyes and keep one awake (excited mentally) and promote attentiveness and alertness. I was thinking of wh
I understand the reason for a time limit and agree there should be a time limit on submitting logs for any contest. However, 10 mins after the contest is just a little too short in my opinion. Too ma
It is true most people have a computer at home, but I run into many and hear many who do not know more than to use internet explorer or yahoo mail. The computers are there, but what about the profici
Hi John Someone correct me if I am wrong, but I have read where this is an attempt to keep unscrupulous contesters from spending a lot of time manipulating their logs (which is understandable). The o
Hi Joe: It depends on brand, I just went through a similar search, couldn't find a list per say but if you will go to a couple of these links and search starting around 1988 -1990 manufacture year th
Mal is right. Also remember when you say Icom you are saying tentec because as far as the CI-V protocol they both use the same computer control methods and protocol. Might add they also both do not r
One other thing to consider: When it comes to DSP you want to look for DSP that is done before the IF stage not what is commonly referred to as AF-DSP which is DSP filtering done in the audio stage o