Author: K3TN via CQ-Contest <cq-contest@contesting.com>
Date: Mon, 15 Nov 2021 10:46:35 +0000 (UTC)
In the Telnet > Filters window, the N1MM Logger software has a nice spot freq "randomizer" setting: Randomize incoming spot frequencies "Automatically adds or subtracts a small amount from the receiv
Author: K8MR via CQ-Contest <cq-contest@contesting.com>
Date: Mon, 15 Nov 2021 12:53:25 +0000 (UTC)
Just please make sure this is done only for CW contests. Calling off frequency on SSB only makes things more difficult to copy, while not leaving the frequency any more clear. 73 - Jim K8MR In the
I think this Randomizer feature is fantastic. But wish one could make it work slightly different. I would LOVE to see it do this, if you clicked on a spot your RX would be dead on to the RX freq, but
Very good point to enable it. it should be automatically disabled in SSB. Barry W2UP _______________________________________________ CQ-Contest mailing list CQ-Contest@contesting.com http://lists.con
The option only applies to CW. The user cannot specify other modes. The option truly is not for the op that sets it at his station. It is set on by default. This is to aid the dx station. It spreads
I really don't like not knowing where my carrier is, so I choose to use XIT intelligently. I leave the N1MM+ feature turned off, but then I dial in between 20 and 60 Hz of offset using XIT when I S&P
YES! I do it slightly differently, setting RIT a bit off frequency with XIT OFF when S&P. That way, I can tweak it if needed for better copy of his exchange. Doesn't matter in WW, but can be a big de
It should also be disabled in RTTY......and everything else except CW. Or, to look at it from another perspective, it should *only *be enabled for CW. __________ Stan, K4SBZ _________________________
Note to N5OT and K9YC, can't you guys just get with The Program? Adjusting the knobs on your "radio" sounds like anarchy to me. cain K1TN I really don't like not knowing where my carrier is, so I cho