Hi all, I was wondering if someone could help me out here? We're running the indoor mount WaveWireless ISP base with Karlnet v3.71 and need to upgrade it to support karlnet's newest software v4.45. I
I got the key file through WaveWireless since it's was their hardware and they had a good promo at the time. We did have a problem with the key file at first but it got resolved. I was able to load &
Try user name: karlnet password: public --Joe karlnet-request@WISPNotes.com wrote: Send Karlnet mailing list submissions to karlnet@WISPNotes.com To subscribe or unsubscribe via the World Wide Web, v
Not sure if this applies to the 205 boards but it's a start. 1) Enable PoE injector on Second Ethernet Port (eth2) Both Pins 1 has 2 jumpers Not Jumpered (default) Jumper both sets of Jumpers (1 & 2)
If you reboot the base does it correct the problem? We are having a very very similar problem and reboots do not correct the problem. Also we can only use one channel to pass ip traffic the rest of t
Has anyone else noticed a problem with the Config v5 & up program where the "Radio Stats" results are all mixed up in the "TurboCell Station Entries" ? --Joe _________________________________________
It should be "J1" However http://www.karlnet.com/Documents/KN-105-KN-205%20Printed%20Circuit%20Board%20(PCB)%20User%27s%20Guide.pdf doesn't say anything about J1. I could be wrong but I believe it's
Let me see if I get this right. Karlnet was bought out by YDI. Right? Then YDI got the ISP Richochet. http://www.ydi.com/company/pressreleases/pr-20040630.php Is it just me or is there a pattern star
Try disabling the watch dog. Also try it without an antenna or anything plugged into the card, I've seen some bad antennas reboot systems before. --Joe _______________________________________________
Has anyone here been able to upgrade from v1.10 to v1.20 on the kn-50 boards with the H1 chip? I just upgraded 2 units and now I'm seeing the "Compatible" warning in the ISP Base. I've had the client
This happens to us quiet often. You need to shutdown the users PC then power it up and all should be good. --Joe _______________________________________________ Karlnet mailing list Karlnet@WISPNotes
Can anyone recommend a high powered card that works in the kn-50 boards? --Joe _______________________________________________ Karlnet mailing list Karlnet@WISPNotes.com http://lists.wispnotes.com/ma
Thanks Blair. Just one more question what software do I use with these cards, is it the H1 or H2 version of the KNUB? --Joe _______________________________________________ Karlnet mailing list Karlne
Change your channel & network ID. We find that on some channels our isp base's will go 4-10 days before we see it do the retransmit loop, while others channels we'll be luck to get a few hours. The b