If you are using flat pannel antennas get a small speed square. It has a flat side and that side goes onto the face of the antenna and the other side you can use for aiming the antenna. It is very lo
I have 2 of these boards and both were locking up at the drop of a hat untill I put a small heat sink on the pcmcia card and used a 12 volt, 1.5 amp power supply on them. I only use them as temp. spa
I use a laptop with an orinoco pcmcia card in it and Karlnet NDIS client software in it. I hook the pcmcia card to a 13 or 19 db antenna and point it at the AP. The Karlnet utility gives me signal, n
Yes, very well from my tests. Bernie -- Original Message -- From: "Norm Young" <lists@applegatebroadband.net> To: "Karlnet Mailing List" <karlnet@WISPNotes.com> Sent: Tuesday, September 16, 2003 8:27
So far we have recieved 20 Ubicom TC uniits. The first 10 worked great. We have had problems with the second batch of 10. About half of the second batch won't connect to some of our APs and the other
I'v tested the several we have on our system befor they are installed and the bandwidth management works just as it should. I still can't read the signal from the radio or the ap but that should be f
Any trees close to being in the way? I have seen your problem when a tree branch blows around, getting in the way of the signal then when the wind quits the problem goes away. Bernie Beckel Crimson W
Heat sinks from an old P2 CPU fit on the radio card well. This is where the heat is comming from so I put the heat sink on the radio card. Bernie Beckel -- Original Message -- From: "Wisp Notes" <wis
Norm, I think we are talking about the same boards. I got some yestereday from CW labs. Mine only has one RF connector but it is plugged into the PCMCIA card via a piece of short coax. I got our firs
Did our second Ubicon install (at my house) today. Got a chance to check it out a bit more. I can't read signal quality through the AP. I am going through an AP1000 with Ver 4.43d firmware. Any body
Here is what I have seen using the KN50s We have 40 of them in service RGs or KN100s work on all APs with less than 1% ping loss We have 17 AP1000s, KN40s connect with out much ping loss to some APs
Its easy. 2 jumpers on the board and a $10 Smartbridges indoor POE splitter from Electrocom and your in business. Hit me off list for details bernie at crimsonwireless dot com Bernie Beckel -- Origin
Got it. Is your email back to normal yet? Bernie test.. _______________________________________________ Karlnet mailing list Karlnet@WISPNotes.com http://lists.wispnotes.com/mailman/listinfo/karlnet