Point 1> Specifically which Prism cards? Prism 2.0 / Prism 2.5 / Prism 3.0 ? Point 2> Generally the Prism cards have LOWER receive threshold which means the exact opposite of what you are saying belo
If "support" to Karlnet means blaming other companies for the failings of Karlnet software then simply revise your list of "supported" cards and remove all references to Intersil and Prism. If you h
Man, you should look into a political career. If Karlnet code only supports the Intersil reference design and none of the card manufacturers follow the reference design then what is the support for?
Brian, the reason that I joined this list was to offer my help and first-hand experience at running WISPs since the days of the Lucent 900MHz equipment. Maybe I did get a little abusive with my poli
I was curious about a couple of things that I noticed while looking at link test signal values from an AP-1000 Base Station that is using EnGenius 200mW cards. reading was valid. Results: Using a CW
I see this happen all the time. I notice this most often on AP's that have more than 40 customers connecting on a single wireless interface. I hardly ever see this happen when there are less than 20
Yes, I do. The loss percentage depends on a number of factors other than just the wireless link (for example, if you are using QoS on your routers) but generally, I consider less than 10% loss to be
In my continuing experiments with Prism 2.5 cards, I have discovered the following: Programming: Slot A interface: TurboCell ISP Base Station w/ protocol filtering Slot B interface: Wi-fi access poin
Your Base Station's Arp table probably needs to be flushed. Assuming you are using SA-4400 Base Station, reboot the base station. ** REPLY SEPARATOR **
Are you wondering about running a point-to-multipoint outdoor network? If this is the case, I wouldn't even think about SEC software since you're considering 64 customers. CDMA works well if all stat
Yes, quite a few are in RG-1100's. We don't use WEP. From experiments that I did, I found that EnGenius and Zcommax 200mW cards only work when in 64bit WEP mode - 128bit WEP didn't work. Additionall
Hi All, I've been using Karlnet for about a year and I only just now stumbled accross this mailing list. I've been going through the past threads looking for some of the problems I've experienced. I'
Hi Darko, I ran into a similar problem when I tried to use Avaya Silver PC cards in RG-1100's. The RG-1100's operated flawlessly for about a month and then all of a sudden, they started dying on us.
Hi Charles, I don't think it is a power draw issue. I've tried just a single high-power card in the AP-1000 with the same results. The reason I don't think it is a power related issue is because the
Both brands of the high-powered card are getting a lot warmer than your typical Orinoco card. We've solved the temperature problem very simply by leaving covers off or adding a small fan in some case