- 1. [RFI] Help on speed drive motor controller RFI (score: 1)
- Author: "Juan EA5RS" <ea5rs@ono.com>
- Date: Sun, 28 Jan 2007 00:00:24 +0100
- A new water pumping station using a variable speed drive was recently installed on the roof of the apartment building where I live, just a few meters from my HF antennas. RFI from the speed drives is
- /archives//html/RFI/2007-01/msg00022.html (7,047 bytes)
- 2. Re: [RFI] Help on speed drive motor controller RFI (score: 1)
- Author: "Juan EA5RS" <ea5rs@ono.com>
- Date: Mon, 29 Jan 2007 23:00:54 +0100
- Thank you very much for all responses, both direct and thru the reflector. It was very enlightning to hear your opinions. When I said the speed controller did not have any RFI filters fitted, I meant
- /archives//html/RFI/2007-01/msg00031.html (11,652 bytes)
- 3. Re: [RFI] I. C. E. products question (score: 1)
- Author: "Juan EA5RS" <ea5rs@ono.com>
- Date: Wed, 2 Jan 2008 01:49:52 +0100
- I have recently measured a couple of ICEs419 (6 band switched BPF) and a Dunestar600 (similar to the 419) with an accurrate Vector Network Analyzer. While frequency response is similar between both m
- /archives//html/RFI/2008-01/msg00003.html (8,418 bytes)
- 4. Re: [RFI] I. C. E. products question (score: 1)
- Author: "Juan EA5RS" <ea5rs@ono.com>
- Date: Wed, 2 Jan 2008 07:58:44 +0100
- Dunestar 200w (as stated in Power Ratings chapter in manual) W3NQN 200w (not 100% sure) But those figures might not be very significant, Under a severe load mismatch, their worst case condition as fa
- /archives//html/RFI/2008-01/msg00005.html (8,500 bytes)
- 5. [RFI] Fence wire material advice (score: 1)
- Author: "Juan EA5RS" <ea5rs@ono.com>
- Date: Thu, 15 Oct 2015 20:50:25 +0200
- I am going to install a 2m high metal fence around the area (20m by 20m) containing shack building and initial towers in our new contest station where we will operate M/S, so must be able to hear wel
- /archives//html/RFI/2015-10/msg00032.html (6,747 bytes)
This search system is powered by
Namazu