- 61. [TenTec] SSB power; was Question about Mike for OMNI V and Corsair II (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Wed, 14 Jan 2004 16:07:24 -0500
- Dan, N4VET: What power do you get when you whistle into the mike? In each case, it should be the same as your CW power. With normal voice operation, the power read on a wattmeter will be much less th
- /archives//html/TenTec/2004-01/msg00457.html (7,252 bytes)
- 62. [TenTec] 9MHz 500HZ filter (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Thu, 15 Jan 2004 09:37:34 -0500
- 250 and 500 Hz filters DO have higher insertion loss so Ten-Tec compensates for this by using an additional stage of amplification. BUT this also causes the 3-5 dB DR degradation ARRL noted in their
- /archives//html/TenTec/2004-01/msg00474.html (9,610 bytes)
- 63. [TenTec] 9Mhz filters (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Thu, 15 Jan 2004 11:12:01 -0500
- with a center frequency of 9.001500, which isn't what the Omni VI is looking for. Correctomundo, Barry! But, 9.001500 isn't correct for the Orion, either. The 9.001500 "standard" for wider TenTec fil
- /archives//html/TenTec/2004-01/msg00477.html (8,668 bytes)
- 64. [TenTec] 9Mhz 500 Hz filter (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Thu, 15 Jan 2004 13:32:06 -0500
- The loss of crystal ladder filters increases as bandwidth decreases because the narrower bandwidth filters are more heavily loaded by the capacitors to ground at the nodes between the crystals. Thus,
- /archives//html/TenTec/2004-01/msg00485.html (9,606 bytes)
- 65. [TenTec] 9Mhz 500 Hz filter (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Thu, 15 Jan 2004 17:03:21 -0500
- My defense on harping on the OMNI VI is contained in my original post on this topic: board, is only $24. Although a purchaser of a $3,000+ radio may not wish to cut corners on a $109 filter, owners o
- /archives//html/TenTec/2004-01/msg00491.html (7,981 bytes)
- 66. [TenTec] Line input on Orion (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Sat, 17 Jan 2004 12:19:27 -0500
- I used my TenTec desk mike for one QSO to make sure everything worked ok, then gave the mike back to a friend to use. SO, I'm using my Heil headset. I don't have the adapter cable. I run it through a
- /archives//html/TenTec/2004-01/msg00560.html (7,471 bytes)
- 67. [TenTec] Buzzing OMNI VI caused by 962 power supply problem (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Wed, 28 Jan 2004 15:38:04 -0500
- On startup there is a buzz (brrrrrr) for a few seconds form the rear center to left of the radio and the display comes up a half brightness. I then tried feeding the radio with 12v from a astron supp
- /archives//html/TenTec/2004-01/msg00862.html (9,241 bytes)
- 68. [TenTec] FS: Delta 580 (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Sun, 7 Dec 2003 11:13:42 -0500
- For sale: Ten-Tec 580 Delta 160m-10m transceiver. Includes optional WARC band crystals, accessory 289 Noise Blanker, well-used matching Ten-Tec 215 ceramic microphone. $200. Buyer pays shipping costs
- /archives//html/TenTec/2003-12/msg00228.html (7,065 bytes)
- 69. [TenTec] Sold: Delta 580 (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Sun, 7 Dec 2003 18:45:11 -0500
- The Delta 580 I advertised today has been spoken for (several times over!). Thanks Terry Zivney, N4TZ/9
- /archives//html/TenTec/2003-12/msg00245.html (6,759 bytes)
- 70. Re: [TenTec] ORION vs OMNI VI (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Thu, 11 Dec 2003 08:33:41 -0500
- W3ULS wrote: It's interesting to compare the ORION's numbers against the venerable OMNI VI. In a QEX article (9-10/02) T. Raczek included a table showing the drop-off in performance between measureme
- /archives//html/TenTec/2003-12/msg00381.html (12,951 bytes)
- 71. [TenTec] FS: Model 234 Speech Processor (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Sat, 13 Dec 2003 17:10:45 -0500
- Model 234 RF-type speech processor, tested with TenTec Delta transceiver, but works with any transceiver. I use one with my OMNI VI+s as RF-type processing gives more "punch" than the audio processin
- /archives//html/TenTec/2003-12/msg00497.html (6,982 bytes)
- 72. [TenTec] Zero cost PTT CW solution (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Tue, 30 Dec 2003 09:32:13 -0500
- I have been happy with my Corsair II and OMNI VI's QSK CW, even on those rare times when using an amp. However, when I upgraded from my homebrew SO2R box to the TopTen DX Doubler SO2R box, I found th
- /archives//html/TenTec/2003-12/msg01280.html (7,567 bytes)
- 73. [TenTec] Orion & Motorcyle battery (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Wed, 21 May 2003 11:07:29 -0500
- I've ordered an Orion and for the first time will be using an outboard DC supply (a used Astron RS-35M is on the way). I often get short power glitches since I am in a rural location and am concerned
- /archives//html/TenTec/2003-05/msg00745.html (10,080 bytes)
- 74. [TenTec] Orion Remote Knob POD (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Fri, 4 Apr 2003 13:21:33 -0500
- I've read thru the operators manual posted at TenTec.com but didn't see the answers to the following questions: Which VFO does the remote knob tune: A or B? Is there a way to select either one? I hav
- /archives//html/TenTec/2003-04/msg00126.html (7,116 bytes)
- 75. [TenTec] Accessory connector for Hercules II (score: 1)
- Author: "Zivney, Terry L." <00tlzivney@bsu.edu>
- Date: Wed, 11 Dec 2002 09:59:03 -0500
- Does anyone know the Molex part numbers for the 15 pin accessory connector and the pins used to connect to the Hercules II? The TenTec manual does not give manufacturer part numbers. The variety of M
- /archives//html/TenTec/2002-12/msg00305.html (7,087 bytes)
This search system is powered by
Namazu