Hello all, I'm looking for a paddle/keyer to match my C-21D. I believe it was the 670, but let me know if I am wrong. Happy to buy or trade. 73, Jim W6JIM
Hello Gentlemen, I have been cleaning my shack while spending so much time at home. I found I have an extra 234 Remote VFO that has a modification of an additional connector in the back panel. The co
Hello All, I have a 6+ that was serviced by Ten Tec last year. Worked fine up until I put it on the shelf for a few months. Just put it back on the bench and now no transmit on 80M? It is pulling amp
Hey guys, I picked up some Airpax breakers so that I can run my rigs without the Ten-Tec power supply. The specs of one of them is a little different from the other two and wondering if anyone knows
I bought a "tech-special" 505 from eBay a few months ago that was beautiful but would not transmit. Gary, W0DVN, fixed it up for me and I got it on the air for the first time Saturday night, 16 Feb,
Happy New Year All, I have had an issue with my Eagle happen twice now. Issue: - Eagle loses tuning and SWR starts going crazy and jumping all over the place - Will not tune with inboard or outboard
Thanks for all your advice, - I removed some jumpers to make a more direct line to my antenna (no shorts found) - I cleaned the contacts on two boards in front of the filters - I also checked all plu
Hello, I am a new owner of an Omni-C. I've noticed that when I operate a particular frequency, let's say 7.124.0 the reverse beacon has me at 7.123.3 I'd like to know if this a normal variance? I hav
Hello, Moving from an Omni-V to a 6 Plus (I can finally afford one!) With my Omni-V I had just two filters. A 500 in the passband and another 500 in the IF. That gave me a "500" and a "Narrow" (N-1)
Here are the symptoms. Thanks for your advice in advance! * All is well except for 15 and 17 * On these bands, No transmit, but receive is fine * No indication of power-out on rig meter or outboard w
Current consumption is high, even at low settings. As I increase the power, it jumps from 5 amps to 20 as the power dial reaches about the 40% position (1100 or 1200). Then if I increase power past t
Hello All, My first post to this group since about 1998 or so! I recently acquired an Omni-C. * Cosmetically perfect * Mechanically/Electrically, fantastic except for one thing..it is always on. The
Thanks for all the help everyone. Problem solved by using the matching power supply. Thanks for all the info about the risk of not using the proper supply. I had no idea that it was an integral part
Hello All, Been using an Omni V for many years. Love the silent QSK. Just picked up an Omni-6 Plus, Seems to be mint, but the QSK is noisy. Lots of clicks. Is this normal for a 6+ or is there somethi
Thanks Barry, That did it! Jim W6JIM Message: 2 Date: Thu, 14 Mar 2019 16:52:54 -0400 From: Barry N1EU <barry.n1eu@gmail.com> To: Discussion of Ten-Tec Equipment <tentec@contesting.com> Subject: Re: