Well, I did it after being around Ham radio 36 years or so. I Just Purchased My First Ten-Tec radio And I have to say I am very Pleased to be able to purchase an American company Radio For a change.
I really would not expect Ten-Tec to address any issue brought up by the group, If fact they probably bite their nails at some of comments .And its not a reasonable to expect them to work around the
Version 2.032 software When operating my new Orion II this am Had terrible Noise with NB set to 2 , NR 3, Notch on and the SP set 3 and sweep on I then went notch C position rotating the Down from 10
setting to confirm Bug Condition setting on radio NB -on setting 2 NR-On setting 2 Notch setting C=1000 W=300 SP on 3 When rotate the notch down below 900hz radio will lose receive and will require a
Happy To report: IF you do a Battery reset and then perform a master reset. This clears My radio of this Bug and can Now run all Noise reductions filters with out losing audio. Thanks to the list and
I am currently using the 709 A Boom Mic with my Heil cables with out a problem its the same 4 pin connector. Phil AI4dq _______________________________________________ TenTec mailing list TenTec@cont
If you live in area where you get man made noise ,then it might be more important feature actually I thought audio was sounding fairly nice , it could be a little better ,Bad audio doesn't make my ra