- 1. [TenTec] Closet (2) Kilowatt Station Available (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Fri, 28 Oct 2005 13:55:24 -0500
- I have the following equipment operational on the shelf in my station: Ten Tec Omni VI+ (not upgraded VI) build date of 10/99, has hand microphone, manual, connectors and cables and 4 extra Ten Tec f
- /archives//html/TenTec/2005-10/msg00383.html (8,518 bytes)
- 2. Re: [TenTec] 9 MHz IF Bandscope for Orion (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Tue, 9 Aug 2005 10:20:25 -0500
- Len, I have used a small cap connected to the mixer output on a couple of boat anchors and fed that signal into my 756 PROII. At the 455 kHz IF of the boat anchors you don't get a lot of bandwidth du
- /archives//html/TenTec/2005-08/msg00204.html (9,747 bytes)
- 3. [TenTec] KR-50 Keyer (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Mon, 22 Aug 2005 11:35:05 -0500
- I am modifying a KR-50 keyer by replacing the internals with a CMOS Super Keyer. I wanted to use the paddles, power supply and case of the KR-50 and remove the dot-dash board to make room for the sma
- /archives//html/TenTec/2005-08/msg00400.html (7,002 bytes)
- 4. Re: [TenTec] Orion II (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Thu, 21 Jul 2005 11:09:22 -0500
- Scott, Thanks for the update. When you made the announcement I looked at Motorola's original announcement of the Dragonball Super VX, published in June of 2001. They announced that the processor woul
- /archives//html/TenTec/2005-07/msg00687.html (16,362 bytes)
- 5. Re: [TenTec] The future of The Orion I (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Mon, 25 Jul 2005 09:39:53 -0500
- We need to remember that this is a faster processor, not a totally different one. It is more like getting a 3.4 gigahertz Pentium to replace a 1.7 gigahertz one. The software should be interchangeabl
- /archives//html/TenTec/2005-07/msg00999.html (13,924 bytes)
- 6. Re: [TenTec] The future of The Orion I (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Mon, 25 Jul 2005 14:41:59 -0500
- I should probably said software modules. When you write a program to operate a piece of equipment you have a main program which is developed (usually in modules) and then you have particular modules
- /archives//html/TenTec/2005-07/msg01033.html (17,247 bytes)
- 7. [TenTec] Voltages on 50 ohm Dummy Load (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Wed, 8 Jun 2005 09:15:45 -0500
- Hello All, I need to calibrate the watt meters on my Titan, Omni VI+ and 253 Tuner. I have a Drake 2 kw PEP dummy load and a nice 200 mHz storage scope. In order to measure output, should I measure R
- /archives//html/TenTec/2005-06/msg00281.html (8,487 bytes)
- 8. Re: [TenTec] brackets (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Sat, 14 May 2005 19:54:49 -0500
- John, I don't have any for sale, but can take pictures and dimensions off mine and send them to you. I have the rack with brackets for the Omni (V,VI,VI+), 253 Antenna Coupler and 425 Titan. They are
- /archives//html/TenTec/2005-05/msg00230.html (8,533 bytes)
- 9. Re: [TenTec] FS: Various Audio filters (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Thu, 19 May 2005 21:35:21 -0500
- Jim, I would like to buy the NIR-10 if still available. Thanks, Barry ________________________________ I went on an audio filter buying spree over the past few months and am going to sell off a few I
- /archives//html/TenTec/2005-05/msg00306.html (8,428 bytes)
- 10. Re: [TenTec] RX 340 vs Orion RX comparison (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Tue, 31 May 2005 09:29:27 -0500
- I recently did the exercise of comparing the RX-340 with a separate transmitter (actually Pegasus) to the Orion, as far as amateur use only. The RX-340 is very limited in the close in distortion rang
- /archives//html/TenTec/2005-05/msg00619.html (9,198 bytes)
- 11. [TenTec] Serial Numbers for Omni (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Mon, 25 Apr 2005 14:46:20 -0500
- Is there a site with estimated production dates vs. serial numbers, or even a description of how Ten Tec develops serials? My Omni VI+ (definitely a VI+, not an upgraded VI) has a serial starting wit
- /archives//html/TenTec/2005-04/msg00591.html (8,525 bytes)
- 12. Re: [TenTec] cw creation (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Tue, 26 Apr 2005 08:44:09 -0500
- Ken, I have an ex-embassy commercial transmitter, the Sunair GSE-924 that injects a 1 kHz sine wave while in USB mode to produce CW. This is a pretty impressive rig, no cooling fan 30 w AM, 100 SSB a
- /archives//html/TenTec/2005-04/msg00617.html (11,196 bytes)
- 13. Re: [TenTec] cw creation (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Tue, 26 Apr 2005 13:09:02 -0500
- This particular transmitter is a 1980s synthesized radio using the filter method to generate SSB. I will look up the manual and see how it is rated for spurious emissions. Since it was built for gove
- /archives//html/TenTec/2005-04/msg00621.html (13,680 bytes)
- 14. Re: [TenTec] cw creation (score: 1)
- Author: "Williams, Barry" <Bnwilliams@varco.com>
- Date: Wed, 27 Apr 2005 10:12:51 -0500
- The 32S-1 did use an audio tone, at the time it was produced Collins was really convinced that SSB was the way to go, so it also goes into the "primarily SSB with CW capability" category too. Concern
- /archives//html/TenTec/2005-04/msg00640.html (9,834 bytes)
This search system is powered by
Namazu