Hello or he is using 1.372 firmware? I had a similar noise in the headphone on on ear, when using QSK faster then 5% and firmware 1.372. 73 de Harry, DK2GZ
Hello I will be in Dayton this year. Will arrive late 19, May afternoon at the airport. My hotel is: Econo lodge south Will be also in Crwon Plaza to meet the contest guys during the Hamvention. 73 d
Hello I am using the following roofing setup: 1Khz in the 1.8Khz slot 600 HZ Inrad in the 1 Khz slot 500 HZ TT in the 500 HZ slot 250 HZ TT in the 250 HZ slot I am working 99% in CW. DSP-Filter aroun
But to be honest. There is also something written about the better keying waveform in QSK-mode! Maybe the first of the new ICOM generation, without shorting the dits in QSK. 73 de Harry, DK2GZ still
Hello TT-Group I just installed the 1.372 firmware. Two things i noticed in difference to 1.371: 1. Click in headphone Using headphones and listen only the main RX, there is a click in right headphon
Bob W2WG I just did some check again. I am dont use BIN-RX mode But the click is more present on 160/80/40 and less on 17 Meter and up I am using LCW for CW on all bands. 73 de Harry, DK2GZ
Hello here the same funny things happen from time to time. Lost the main rx, lost the sub-rx Signals sounding strange like aurora signals. Power off/on start the Orion normal again. But will not do i
Hello TT-Fans, I decided to go back to firmware 1.371 today. I am doing 99% CW this this radio. Why did I reload the 1.371 firmware: 1. the new keyer function does not work for me, still stuck in cut
Hello I also have a TS570D(G) but there is no truncation of character elements. I believe the TS570 is one of the best sounding cw rigs, also in qsk mode 73 de Harry
Hello to transfer also the BW and Mode with the A-->B button, simply activate the tracking in the menu. Then also the same BW and Mode is on the 2. RX Cant tell you the menu item yet because my ORION
Hello I have read the discussion about the OMNI 6+ and the roofing filter in the Orion. Here some notes by a CW operator: Nearly a week ago I was fighting very hard with me to switch back to the OMNI
Hello all here are the first impressions after one week of usage(used an OMNI 6+ for several years before): PRO: 1. RX is nice, but the factory default setting for the AGC a little to noisy for my ea
Hello Jack I set the prog AGC: Hang 00.00 decay 5 db/s threshold 47.87 uV NR off or NR 3-5 then you can deal with the decay up or the threshold a little Harry, DK2GZ
Hello my OMNI 6+ is maybe oscillating on 80 meter. I can here my tx-signal very wide on 80 meter, about 500 KHZ up and down on a second receiver. Also the external SWR-bridge shows a bad SWR, but the
Hello I had replaced diodes D6, D7, and D8 on the Low Pass Filter Board last night. Problem was an oscillating TX on 80 meter. I have installed 1N41007. Now the TX is absolutly stabile but the the RX