Hi Ron, That was the second place I went to find them, the first was my box of amp parts (or what's left of it). I'm looking for the proper pf values but I want to replace what's there with proper si
Here's a photo of the blackened wires. If you look at the two small doorknobs below & under the toroidal transformer, you will see the two un-shielded wires going to the top of them which are black.
-- I was waiting for the O2 to get it's firmware updated before ordering one. I've been following this reflector for several years now trying to decide when was the right time to buy one. When the O
My 2 cents: TenTec support should make an official presence on the TenTec reflector. Much positive would be accomplished in more than one way. Period. Gary KA1J
Dennis, I might have what you're looking for. I have an Omni V with Carl's chip in it. It has the 2.4, 1.8, 500 & 250Hz filters. It's in pretty nice condition. I also have the interface connector for
I suspect that one of the reasons people ask here is because this is a users group & a lot if not most of the people here enjoy the equipment and are able to share easy answers and some solutions to
Darned if I can remember the connections for the Titan 425 to the Corsair. I want to get the sequencing right for QSK. Anyone know which goes where so both units are copaesthetic? Thanks, Gary KA1J
Hi Jerry, I use an external keyer so I can't do that. The key in you'r thinking of is where I need to put the key. If I hook it up the way you're thinking it would work fine but I'd need to use the i
Hi, I have several TenTec items that are excess to my needs. I'd like to have an idea what they are worth. They are: 1.an Omni V in quite good physical and working condition. There are very few minor
Addendum: " 1. Select the desired mode with the pushbutton switches. The mode chosen will be indicated by the LED display to the right of the bargraph. "A" is ther Corsair, "B" is the 263. Thus if th
I don't have any top end rigs but I do have a Omni V v.9 and my father who lives in the same house is on 80M with a KW amp every night. I just moved my vertical antenna to a salt marsh beside us and
Any easy way of adjusting the tuned input of my 425? My Omni shows a 1:2 swr on 80M when running the amp. With the amp in standby as the well as off, the Omni shows a 1:1 to the antenna. The SWR mete
Ron, I don't remember it being 1:2 last year but it could be insidious and crept up on me. Guess I need to break out the old tel-Ohm-Mike & see what they show. Gary KA1J
Jim, according to the 425 30 W drive gets me 900W out I have an extra pair of tubes that were tested as full output and I've seen no difference between the two pairs so I'm guessing on this amp 30W i
I like CW and prefer 250Hz narrow filters, especially on the noisy lower bands. I am thinking of replacing the standard 9Mhz filter with an Inrad The optional 9Mhz filter with an Inrad #760 9000.75 K