I am not sure but I think all Ten Tec supplies have the breaker. Could someone else on the list check this out for Rich. I do not want to give out information I am not sure of. Dan/N4VET ____________
Ten Tec no longer stocks the breaker they called the 1040. They urge all persons using a non Ten Tec supply to use a 1040 breaker in the positive line. You can find this information in all the manual
Sorry fellows I just looked at my last post and noticed that I had stated 1040 breaker. Should have been 1140. My bad. Dan/N4VET _______________________________________________ TenTec mailing list Te
Well said Bob. If your load is reactive and you do not have a Ten Tec supply or a supply that puts out more than 20 amps without a breaker you can kiss the finals bye bye. Less chance of this mismatc
You are right Duane. I have never had one fry. All I use are Astron supplies. And, as you can see most people who follow Ten Tecs recommendations seem to do fine. Read the manual! Dan/N4VET _________
Martin, you might want to check if it does it with amplifier out of line. Could be a bad cable from rig to amp or could be a problem with the tuned input of the amplifier. Dan/N4VET _________________
I just asked Carl the same question. Maybe he will send the list the information. This could be a good one for the archives. Dan/N4VET _______________________________________________ TenTec mailing l
Yes, it can. In the form of heat and smoke from the finals right before they die trying. Dan/N4VET _______________________________________________ TenTec mailing list TenTec@contesting.com http://lis
It will be a multi color dot that will change color with the display. It will work to perfection after version 5xxx release of the updated O2 software. Dan/N4VET _____________________________________
You left out the reply. How can we tell if it is funny? Dan/N4VET _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinf
Goes to show you Keith. The economy must be doing real good if that much money can be spent on a hobby. I have an OMNI V it has the green numbers and a 4 pin mike plug along with an analog S meter. I
The economy must be doing real good if that much money can be spent on a hobby. I have an OMNI V it has the green numbers and a 4 pin mike plug along with an analog S meter. I like the numbers becaus
Drake used the PL-58 plug. The OMNI V used the 4 pin mike plug. The Orion II is now up to 6 pins. By the time we get to the Orion III we will be looking at eight pins. And, the nightmare of burned fi
If anyone has a set and is afraid to use them they can donate them to the N4VET "Get the Lead Out Program" or GLOP as it is sometimes called on the left coast. I will take out all unwanted headphones
I have found that nothing can be said that does not eventually gets a negative response. I know that reading this list can cause eyestrain, that could lead to permanent eye damage, but I read it anyw
I don't think it is only California judging from the responses on the list. I think the FAA needs to be made aware of this hearing loss problem since 98% of pilots wear headphones during flights. Dan
Had the same problem with my Astron. But, get this. It went into hum when and only when my wife turned on her handheld hair dryer in the master bathroom on the other side of the house. I never could
Buy a Ten Tec supply or go with an Astron and an Airpax breaker in the positive line to the rig. Junk the one you have. It could fry the finals on that fine Paragon if you try to tune up with it. I w
I've never used a home-brew supply but I have run an Astron RS-35M with a Corsair II and an OMNI V using an Airpax 18 amp instant on the Corsair II and an Airpax 20 amp fast break on the OMNI V. I ha
Larry, I think it is time to trade that rig in at TenTec. The way it is acting I would not even try to sell it at a Hamfest. You will never be rid of the buyer. It is a good time to trade up to one o