The feet had "melted" ( for lack of a better word),,,, I've had trouble with small "stoppers" purchased at Home Depot. I used these for feet on home-brew equipment, and they reacted with the wood fur
It happened rather quickly, which leads me to think it is a trap failure (ugh), but I wonder if that would manifest itself on all bands. ___ I had a TH3-JR and started to have poor receive issues tha
am at stage where must decide if or if not to install L10 C43 sensitivity boost parts I had mine installed, but pulled the cap later. I have found this radio to be very difficult to adjust correctly
Keesler! Were we all there? It was 69 (with hurricane Camille) and 70 for me. After tech school, I ended up repairing the equipment they taught the controllers and other maintenance techs on. Then of
Need schematic for Ten-Tec 3 position CW audio filter for Triton or 509. Read that it was the same as the Vectronics CW filter, but I traced my circuit out and it isn't. It's very close, but no match
Hello Rick... What value are the feedback caps? Mine are .0022, and the output from each section is through a .1uf cap. The first and last sections also have a resistor to ground at the output of the
__________________ Yup, we have to remember that an e-mail address can easily be hijacked. It's happened to my business e-mail address several times this year, but mostly from spam factories. However
I saw a note someplace from an individual who said they were unable to get enough regen control on the higher two bands to reach the oscillating point. Mine will oscillate at some points throughout t
Tom, Most operators want to go the other way by speeding the transition between transmit and receive to eliminate a "thump" or "click" between dits. This is done by changing the value of C1 to .1mf (
Tom, I use a Jackson Harbor PK-3 mounted to the final heatsink above C66 using a black plastic standoff from Radio Shack. I've taken the triple phono jack board, removed the actual jacks and replaced
I have a Ten-Tec 2591 handheld that I purchased when they first came out many years ago, and I'm in need of a battery pac replacement. I have two of the original battery holders that can be refilled
Now this is great news. I'll check with Ten-Tec. I've had mine lock up, but removing the battery has always cleared it after a couple hours...so far. Thanks for the info, Joe
Amen... Check the obvious first. Connect a borrowed (stand alone) dummy load directly to the Argonaut V output through a short, known good, newly built, 50 ohm coax jumper, and see what the rig's met
Occasionally, my 1320 will slightly jump frequency between the first dit and the second dit (or dash) in a string. This usually happens at the higher frequency setting of the VFO within the band. I s
Brings up a question... Does the meter on the Argo V read peak on SSB? If not, the meter would probably read low. What does the manual say is a normal reading or do you just adjust for an ALC flicker
I've had the RS-35M for at least three years, and have never had the problem. 73, Joe ( WJ5MH ) -- StripMime Report -- processed MIME parts -- multipart/alternative text/plain (text body -- kept) tex
I have a 1320 with downward drift that seems to be initiated by transmitting. Is this common or a specific problem to my rig? I've done some troubleshooting, but nothing extensive. Notes: I've tracke
Thanks for the valued input, and it looks like I'll have to spend some time on this one. For now, here are my statistics: Cold Start... 7.867460 After 30 Min... 7.866431 Downward drift of 1.029 Khz.