Last summer when I was considering my purchase options I bought the subject manual. I ended up buying a Jupiter. So.. if there is anyone out there who has the rig, but not the manual , let me know an
I wonder what is in that new matching external speaker for the Jupiter that would justify me spending $98.00 for it. I am sure it probably will look very nice sitting next to the Jupiter... but as th
I was going to wait until the rig came back from Ten-Tec, but given Brian's post earlier today, I thought maybe I should let you know what has transpired. Paul Quentin at TT did advise me on Friday t
I have already reported to the readers here that Paul at Ten-Tec advised that it was necessary to replace the finals in my Jupiter. Rig should be on it's way back tomorrow. My obvious question at tha
Thank you Cecil. If nothing else, "peace of mind" is certainly worth a $9.00 investment. I WILL DO IT! Bill, W6WLB Bill Costa Mesa, CA Amateur Radio Station: W6WLB
Sounds like another vote for Cecil's recommendation to get a fast acting 20A breaker and stick it the DC line to the Jupiter.. Thank you for your response. This list surprises me every time Bill Cost
My Jupiter should be back on Friday with the new finals. I did take the recommendation of Cecil and ordered a fast acting 20A circuit breaker from Poco Sales to place in the line from my Astron RM-35
I got my Jupiter back today and all seems well. I was hoping for some enlightenment in the paper work, but all it says is "Replaced shorted finals; checked operation..OK" So I guess I will never know
Two or three months ago when I struggling to get my Heil HM-1/HC-5 mic to work with my Jupiter.. I bought one of these mics from Mucician's Choice ($9). IT works well although a little "bassie" for m
I don't want to start the mic discussion all over.. but.. I was wondering if Ten-Tec has ever produced a mic suitable for a "boom" type of installation. I really don't like hand-helds or desk mics wh
Just was looking at those images and my impression is that this radio is wide.. much wider then the Omni VI for sure. Just trying to scale it, assuming that the VFO knobs are standard and it would se
I have a behavior on 10M which strikes me as a little different. If I use my MFJ-989C to tune either my 80M dipole or my quad which is not quite resonate on the higher portions of 10M.. and I tune it
Not Ten-Tec related, but I figure someone on this list has probably got the answers. The propagation reports are using new terminology (to me anyway) to forecast conditions related to radio propagati
Well .. as usual.. a VERY quick response. My thanks... especially to Jeff and Jim who took the time to respond promptly to my inquiry. Bill Costa Mesa, CA Amateur Radio Station: W6WLB
I was sitting here happily working on 17M (1.5:1 SWR) and the rig lost all power. Supply voltage is OK. The 25A fuse is OK... When I pulled it off the shelf a few minutes later, heat sink was still H
After everything cooled down, I tried it again, and it came back to life. Must be some sort of thermal protection in there. Still VERY concerned. Not a good thing for a Friday evening. Bill Costa Mes
I was hopeful to no avail. Rig was back on line for maybe three minutes... and it again powered down. Heat sink VERY hot.. Did no transmitting at all. Receive only. I think I better wait until Ten-Te