Along those same lines, a good friend here had his computer and Yaesu FT-1000MP connected together, but both were disconnected from both power and antennas. Still, a direct hit on his antennas absolu
Does the 301 work if you plug it thru the Y-adapter and have the other side of the Y disconnected? If not, then you may have gotten a cable that does not have all the pins wired. 73, Duane Duane Calv
His question wasn't how to get it to tune there, but why did it sound deaf there. I haven't tried to tune down there, so I don't know what I should be hearing if I were to do that. Looks like I can't
My Centurion was in the shack for 5 years, and other than an early life fail of the bias transistor, I never had a single problem with it. Ran it with my Omni VI+ in RTTY contests, QSK CW, and even a
I just sent Bob a note offline saying the same thing. I find keeping the DX station "front and center" by routing the MainRX to both ears helps me better hear him under the cops/lids. I route the Sub
Actually, while the numbers may say the 500 Hz filter with its extra preamp "causes problems," at my QTH it has helped a lot, especially during RTTY and CW contests. Now, I don't have stacked monoban
Here it is, the end of October, and I was hoping for at least a photo of the new Orion II on the web site. Was a little surprised not to see that, but then the day isn't over, so maybe it's still com
Obvious question - has he tried adjusting the "SWR Set" control to at least 3/4 scale? Also, which scale is he looking at? If he's got it set for SWR, and the antenna is alerady low SWR, obviously th
George - I've seen them at either Lowe's or Home Depot. They are clearly marked as non-RFI dimmers. I installed one on my dining room lamp and don't get any noise from it. 73, Duane -- Duane Calvin,
Yes, 705 works fine with the Orion. Used one on mine until I got the Studio 1. I believe the difference is the 705 includes the ability to add a battery to power the electret in case you used it with
That's old news, and the deal soured. Now Maytag and Whirlpool are planning to merge, if I remember right. 73, DUane -- Duane Calvin, AC5AA Austin, Texas http://home.austin.rr.com/ac5aa
Lawrence, I've been running WriteLog with the Orion for at least 18 months now, and for some reason it will occasionally say "No Rig!" on WriteLog. I don't use the Y-cable or a SteppIR. I don't know
Hello Sarla, You have asked in the right place for these microphones! And, thanks to you, I know where Mumbai is. I hope you get a good response from someone. 73, Duane http://creative.mediaturf.net/
Due to the shift of purchase orders from an Orion to an Orion II, I have an excess Inrad 600 Hz filter for the Orion. This is the one everyone speaks about that helps provide a narrow roofing filter
Naturally, I meant for that to be a private email. Sarla has been in the area visiting for a few weeks, and it has been a delight to get to know her. I hope someone can help her with the microphones
Actually, it is a friend who had an Orion on order, but switched to the Orion II when it was announced. Because he had pre-ordered filters, we did some horse trading, and my #352 was left over as th
Thanks, everyone, the filter is sold. The new Orion II is not for me - a friend had ordered the Orion, and switched to the Orion II. In the meantime, as he was waiting for the Orion, he had ordered s
Sorry - Looks like my "old timers" disease is getting worse - I just sent the same append twice. I should get more efficient and just resend the same one instead of writing it twice! 73, Duane Duane
Vince, I think we need more information on your configuration: Are you hearing RF on the MONITOR audio, or just in the headsets without the monitor turned on? (i.e., are you hearing RF on your transm
Paul, Have you tried a reset? A couple people I know of have had "encoder" fails of the type you note (or, for example, they only count 1 KHz in either direction - RIT controls), and they have been f