"Two SO-239" Are they assignable? Can it be used with two antennas for diversity and/or beam steering with the two receiver option? Essentially, is receiver processing set up for phase coherency? Can
Thanks for answering my 594 questions Petr! I'll get on the 594 list and likely order one when desired receiver function is in place and has seen a bit of use. 73, -bob AH7I -do not look into LASER w
I see the new Tentec Phoenix description and read Mike's comments. I'm still interested, even after seeing the price. But, want more info. BOM and circuit diagrams would be nice. With old Tentec, the
No. Not giving up on TenTec! I'm not using these much(at all:). Urban RFI has been discouraging. I picked up a 56' mast and can't stop imagining a new IC-905 in the shack. Also need one short and one
Some how I did not receive the original digest message re: this amp. If it's the Hercules 2, power supply is 12v. Big. Heavy. It's four linear supplies. Each with its own transformer. If it's the Her
It turns out that the Eagle is not a good candidate for remote operation. Because, while PBT and RF gain can be read remotely, they can not be set remotely. So, one Eagle is for sale. Which one? Aski
Aloha all, Today I collected an Argosy 525. I have not checked out TX. RX is outstanding! I can not believe how quiet the audio is. It's got two 8 pole filters 2.4 and 0.5 kHz and the calibrator boar
"Works as it should" = 5W and notch pot noisy. CW note is good though. RX is hot, it's got 8 pole filters, it's clean. So, not overly disappointed. It's the rare bird that does not have problems. Eve
Aloha Charles! Thanks for tips. As far as power. Dummy Bob did not read manual as carefullybas he should have. Power switch in rear panel. Hi-Lo. 73, -bob ah7i
Ron, Have a look at the Ten-Tec tuner schematic. It's a slave to the CPU. It has some line buffers and serial to parallel latches. The ATU-100 has a controller, relays, and reactances. Clone the Ten-
Try another email or give TT a call. I recently purchased buttons and a synthesizer board for my Eagle. Price was reasonable. TT does not have the springy foam for the Eagle, only the buttons. Three
Back story: I bought a dead Eagle expecting it to have a good tuner board. I've repaired everything except the tuner board and the FRACN Synthesizer board. Wanted: 1. Another dead Eagle for parts. Ho
I modified my Eagle to replace 12 V with the key(transmit) line at one of the two 12 V accessory RCA jacks on the rear panel. So, I no longer need this little cable. Center pin of acc to center of RC
My Eagle project will be done any day now. The last part is in the mail Looking for a complete, non-working(so inexpensive) Argosy. Will consider another Eagle project or maybe an Omni VII. Have $ pl
1. Does anyone know the I2C clock speed in the Eagle 599. 2. I have two and a half Eagles. One of the two complete Eagles is misbehaving with regard to the multi-control. I don't want to replace the