Facts: There are over 7 billion people on this planet! There are more than 3.5 billion people on this planet who do not understand the metric system! Testimonials: Ben Livingston writes, "I was visit
What's the Dallas PN? Website illustrates procedure similar to our 'fix' for Sun work stations. http://www.tns-soft.com/nvram.html IIRC, we'd cut a notch on the top near the end, popped the short par
Aloha all and happy new year! Ten Tec 1. Eagle accessory connector manufacturers PN? I'd like to order a couple. 2. Any word on updated Eagle schematics? 3. Turn off the Eagle AGC? 4. 565/566 top and
I always have trouble with the attack when fixing my own stuff while having no problem with ideas for other peoples stuff...so here goes.... My first suspect, based on what you have done so far, woul
Phil If you have stuff lying around, it's gonna be cheap and fast to make up a cable. Last night I made up a cable for the Eagle. Took about 15 min. I used the three circuit audio/video cable scroun
Any suggestions? I'm thinking 3 SPST reed relays . One to switch the Tx antenna. One to switch detuner for the Tx antenna. One to switch the Rx antenna. The reed relays switch in ~1ms so the 17ms tra
In case the sketch on my earlier email was stripped.... To clarify... I want to work CW break in on 160/80/40. I can not use my TX antenna for RX on 160 and 80. Urban Atlanta is much to noisy. I'm in
Decided. I'm going with the three relay solution. I found some "reed" type relays with specified ~1ms switch times and 10^7 cycles lifetime. All SPST. When receiving, power will be applied to the rel
Dwight I don't know the Corsair but based on it's age... Perhaps component value changes. In some of my older tube gear it has led to poor stability of a heterodyne xtal oscillator. You can check if
Finally got to spend a little time on it. Sub-receiver not working so no MWBCB. Still need to test TX on SSB. Otherwise seems OK. Need speaker and sheet metal parts. Not sure of details. Attached vid
Paul If you want to try your hand with a SMT kit, Try the Si570 kit: http://www.qsl.net/k5bcq/Kits/Kits.html $44. including postage. Not drop in but if you like messing around with electronics, you c
Has anyone done this? I've been playing with my new Eagle and am considering the addition of an Afedri board, http://www.afedri-sdr.com, to use with the PeeCee and SDR software for a panaromic displa
I would use this for the buffering of the 9MHz if output: http://www.cliftonlaboratories.com/z10000_buffer_amp.htm 73, Barry N1EU Barry Thanks. It looks like it will do the trick if I can either relo
If anyone has or gets wind of an unrepairable 565 or 566, I can use the enclosure snd some of the mon electrical bits inside. This to complete the hamfest basket case 565. Thanks! 73, Bob ah7i/w4
Rodney Hey! Thanks. How did you end up with just the top? Is it the same as the bottom, minus the feet? Do you know where the bottom is? I'll try to post a photo of what I have sometime tomorrow afte
I'm still getting used to this new Eagle and there's something not right. About 2 hours into extended CW QSO the noise floor came up. At first I thought is was local. S5-S7 making copy difficult. I d