I'm looking for the manufacturer and PN for the band data connector on the Hercules 2. (Tentec 420). PN in manual does not appear in Molex catalog. I do not know if it is a Molex connector. I can wor
Aloha Andy! Thanks. I'm trying to get the amp to change bands with my Eagle. Per the schematics, the same enable-3, data latch, and data clock used for selecting the LPF in the Eagle are available on
The current Tentec is not currently selling new ham gear and it appears from the letter, it is not currently selling any Omni VI parts. The current Tentec appears to be responsive. Just not with the
Aloha Curt! Have you looked at the AQRP VFO? $40. Si570 based. http://www.qsl.net/k5bcq/Kits/Kits.html PA0KLT VFO kit. $45 or so (price is in pound sterling) Si570 based. https://www.sdr-kits.net/ind
Talofa Mike! Mouser sells an encoder without detents for about a buck or try to remove the detent mechanism from the one that comes with the kit. 73, -Bob ah7i/w4 -- -do not look into LASER with rema
Do you really want one? I have been using gmail web based client for years and it works great. I can check mail on cell phone, windoz box, or linux box. I receive email from a number of different add
Make a note of noise levels in the cabin, no antenna. Now grab some clip leads and try it with the car battery. Car off. Away from the cabin. No antenna. If you still have noise, make a note of how i
are you using the more than one cable to the laptop? try keying rig with only the USB control cable and a manual key. -- -do not look into LASER with remaining eye!
No output from Eagle A friend cross country is looking at one and there is no output. Does anyone know what the signal level is supposed to be going into the driver board? Thanks, -Bob ah7i/w4 -- -do
Aloha Mike! You might consider an outboard audio notch filter. Radio shack used to sell one that turns up at hamfests for about $30. There are others but I am not familiar with them. Another option i
I think my post went missing. Autotune. Power is reduced because relays are hot switched while tuning and rating is lower than for static condition. If your power supply has an ammeter, you'll see lo
Does anyone know if Tentec will be producing electronics enclosures? I would really like to have an enclosure that matches my Eagle. I'd like to put a power supply, speaker, antenna switch, relay for
I have a low pass filter board for a 565/566. I want a tuner board for a 565/566, 588, or 599. I was planning to use the filter board with a home brew, ala wa2eby, 50w HF amplifier. Amp morphed into
Aloha Mike! Either will work. If you use the 1/8" jack make sure to wire your plug with ring and sleeve shorted. The Eagle checks for this to learn if you have a straight key or a paddIe connected. I
I am using a battery at present. It works well but but I do not charge indoors and with an expectation of increased operating time, charging is going to be a hassle. Also, once past 20% discharge, it
Does anyone have an electronic copy of this manual. I can not find it at the TenTec web site. I'd like to examine with an eye toward rolling my own. I read somewhere that it is actually four separate
Robert Thanks for info on HP supplies. I actually have one and have used it to power the Herc 2. I was able to trim the voltage up to 12.3 at the edge connector. The best this gets me at the collecto
Bob I do not know what is up. I have been replying to your emails. I have not been receiving any bounces. Perhaps they are going to your spam folder? In case you don't find the latest, just sent, ple