Gary has sent me the Corsair QSK mod and I have posted it on the TenTecWiki. It is available at http://www.tentecwiki.org/doku.php?id=561 under "Mods & Fixes". Thanks Gary! Alan N5NA http://www.tente
Is this it? http://www.tentecwiki.org/doku.php?id=562hiss 73, Alan N5NA http://www.tentecwiki.org Bruce Ellis wrote: Thanks to all for your info. I have not had much success communicating directly wi
There is a low power mod you can do. http://www.tentecwiki.org/doku.php?id=585lowpwr 73, Alan N5NA http://www.tentecwiki.org john ferro wrote: thanks to everyone here i have solved two of my paragon'
New referral program from Ten-Tec. You can earn $ 50 for the purchase of a new, used, or demo original Orion or Orion II transceiver by a new customer or $ 40 for the purchase of a new, used, or demo
I've had this problem before. It has occurred when unplugging the headphones. I just plug and unplug the headphones and it comes back. The bypass/disconnect in the headphone jack is apparently flaky.
Ron, Send it to me and I can post it. 73, Alan N5NA Can someone to put the letter up on a web site, somewhere, anywhere... before I send out another exponentially growing mass mailing? Please. :) Adv
FYI....Ten-Tec had a used Orion II w/o tuner on the May 24, 2007, list for $3295. Another FYI....I've been adding the Ten-Tec used/demo list to the TenTecWiki since May 10. It is available at http://
Jack, You might give this a try. http://www.tentecwiki.org/doku.php?id=563keyer 73, Alan N5NA http://www.tentecwiki.org Jack Mandelman wrote: Several days ago I acquired a beautiful Omni 6+ (564), an
With all the posts about the IP address I decided to check my Omni VII to see what the deal is. I found can set any of the radio IP addresses or G8way IP addresses anywhere between 0.0.0.0 to 255.255
Denton, The December 7 used/demo list showed they had them. You need to call Ten-Tec direct. It's unlikely you'll get a response from Ten-Tec by posting to this mailing list. 73, Alan N5NA http://www
Paul, You need to go to http://lists.contesting.com/mailman/listinfo/tentec and unsubscribe using your current email address. Then, go back to that page and subscribe with your new email address. The
Aren't the Argonaut II and Delta II basically the same except for the power output? If so, this may help: http://www.tentecwiki.org/doku.php?id=536addr 73, Alan N5NA http://www.tentecwiki.org Paul St
Why don't you open it up and poke around. Check all the connectors and make sure all the screws are tight. A while ago someone found a toroid bent over on the bandpass board causing a high current sh
I believe that only works if version 2 firmware is loaded. I don't think you get that indication with version 1 firmware. 73, Alan N5NA Happy holidays. 73, Rick VE7TK Subject: [TenTec] Orion, how to
Page 3 of the manual for the OT-11P says: "Congratulations on selecting the OT-11P tuner for your Ten-Tec Orion and Orion II transceiver." So, it appears it is supposed to work with the Orion II. 73,
Karl, I'm no expert on these mics but the one with the 4 pin connector is probably a model 214, which has an electret element requiring 8 - 12 volts. The 215 has a ceramic element. Please see the wri
I think you need to use the high position. On an archived Inrad web page it says concerning the filter curves: "The top graticule is labeled REF, and is normally 0 dB. The filter insertion loss can b
$8.50 from Ten-Tec. http://radio.tentec.com/Service/Manuals 73, Alan N5NA http://www.tentecwiki.org Ktnjoepark@aol.com wrote: I just aquired a ten tec AC-5 antenna tuner for my Argonaut 509 station.
http://www.tentecwiki.org/doku.php?id=s30 73, Alan N5NA http://www.tentecwiki.org ** See what's new at http://www.aol.com _______________________________________________ TenTec mailing list TenTec@co