From the reflector archives the Omni VI+ showed up on the Ten-Tec website as being discontinued in February, 2002. There's a good lineage on W8KC's website by K9IUA. Unfortunately it hasn't been upda
Yes, that is correct. I meant to make reference to that in my post but I forgot. We are lucky to still have his website available. It will probably disappear one of these days. 73, Alan N5NA http://w
The detailed info on the 961 shows 22 amps output. Guess I need to correct the power supply index page! The detailed info can be viewed by clicking the model number. 73, Alan N5NA http://www.tentecwi
Yes, there is. Check the firmware history. Version 1.012 Add Internal Temperature Control of approximately 70deg C Version 1.014 Increase Over Temp Shutoff Temperature When 1.012 came out there were
I believe the 963 is the same as the Astron SS-30. The SS-30 schematic can be downloaded from several places on the internet. ( http://bama.sbc.edu/astron.htm ) According to the Astron website it doe
Karl, I'm no expert on these mics but the one with the 4 pin connector is probably a model 214, which has an electret element requiring 8 - 12 volts. The 215 has a ceramic element. Please see the wri
I think you need to use the high position. On an archived Inrad web page it says concerning the filter curves: "The top graticule is labeled REF, and is normally 0 dB. The filter insertion loss can b
$8.50 from Ten-Tec. http://radio.tentec.com/Service/Manuals 73, Alan N5NA http://www.tentecwiki.org _______________________________________________ TenTec mailing list TenTec@contesting.com http://li
Some info on the 311 is at http://www.tentecwiki.org/doku.php?id=311 . It is no longer available from Ten-Tec. 73, Alan N5NA http://www.tentecwiki.org _______________________________________________
I stand corrected on the availability of the 311! Rick, VE7TK, contacted Ten-Tec and was advised by Paul Clinton the 311 is NOT discontinued but is a current product and they will be happy to send a
There is a nice lineage of Ten-Tec equipment up to the Jupiter on W8KC's (SK) website at http://mywebpages.comcast.net/w8kc/lineage.htm . 73, Alan N5NA http://www.tentecwiki.org _____________________
John Henry, KI4JPL, writes the firmware for the Omni VII. He closely monitors the Omni VII Yahoo Group and is giving outstanding support and feedback on the Omni VII firmware. Today he announced on t
FYI....Ten-Tec had a used Orion II w/o tuner on the May 24, 2007, list for $3295. Another FYI....I've been adding the Ten-Tec used/demo list to the TenTecWiki since May 10. It is available at http://
Jack, You might give this a try. http://www.tentecwiki.org/doku.php?id=563keyer 73, Alan N5NA http://www.tentecwiki.org Jack Mandelman wrote: _______________________________________________ TenTec ma
With all the posts about the IP address I decided to check my Omni VII to see what the deal is. I found can set any of the radio IP addresses or G8way IP addresses anywhere between 0.0.0.0 to 255.255
Denton, The December 7 used/demo list showed they had them. You need to call Ten-Tec direct. It's unlikely you'll get a response from Ten-Tec by posting to this mailing list. 73, Alan N5NA http://www
Paul, You need to go to http://lists.contesting.com/mailman/listinfo/tentec and unsubscribe using your current email address. Then, go back to that page and subscribe with your new email address. The
Aren't the Argonaut II and Delta II basically the same except for the power output? If so, this may help: http://www.tentecwiki.org/doku.php?id=536addr 73, Alan N5NA http://www.tentecwiki.org _______