I believe there are three different values used: 4-20pf (qty 3), 1-6pf, and 10-60pf. I believe the direct replacement I used was a Murata TZ03 series which are now obsolete. The trimmers are color co
I've got a new Newhaven monochrome display NHD-320240WG-BxTGK-VZ#-3VR-C I originally bought this to install in my Orion 565 but never got around to doing it. According to Onno, PA1AP, this display sh
These are hard to find - Ten-Tec Model 1150 Over Voltage Protector in beautiful condition - highly recommended for use with Ten-Tec power supplies and all Ten-Tec radios using the 4-pin white molex p
Good advice from Don. Also, don't adjust anything until you first adjust the BFO oscillator trimmer capacitors, described in the manual under TX Audio Board. Master oscillator adjustment is described
These cw filters are all fully tested and perform perfectly. They are designed for the cw operator who likes a slightly lower pitched sidetone than the stock 750hz pitch sidetone. Priced as listed. A
If anyone can use this, please contact me and we'll work out details. I've got an interface cable with embedded electronics to interface the Orion band/data connector to the Tokyo High Power DIN conn
The only thing the xtal filtering accomplishes in the Orion is to prevent overload of the ADC by off-channel signals. 4 Poles is plenty. No, the filter skirts are determined by the number of taps of
These filters are for the 9MHz I.F. in the Omni V, Omni VI, or Omni VI Plus and are fully tested. Add $5 shipping (CONUS) per order. Inrad #753 400hz $75 Ten-Tec #221 250hz $60 73, Barry N1EU
The Ten-Tec Wiki, formerly hosted at http://tentecwiki.org, has moved to http://tentecwiki.eqth.net Up until now, a message has advised you of this change when going to the old address. That message
I believe the move is to make the Wiki easier to maintain and finance. Alan N5NA and I have been handling it for quite a number of years. I plan on being less involved, at least for a few years. 73,
My Omni 6+ is looking for a new home. This truly exceptional, one of a kind, radio has one minor issue that will need to be addressed by the new owner. The receive signal has an intermittent slight l
These filters were pulled from my Omni 6+ which just sold. They are all fully tested and perform perfectly. Priced as listed. Add $5 shipping (CONUS) per order. SSB Filters Inrad #754 2800hz 9MHz IF,
I've got a nice Orion subreceiver board for sale, in perfect condition. It was removed when I installed the RX366 subreceiver. I believe it fits either the Orion 565 or Orion II 566. I'd like $100 fo