Search String: Display: Description: Sort:

Results:

References: [ +from:billogden@optonline.net: 6 ]

Total 6 documents matching your query.

1. [TenTec] Headphones (score: 1)
Author: bill ogden <billogden@optonline.net>
Date: Wed, 04 Jun 2008 17:43:13 -0400
I need new headphones for my Orion 1. Am looking at the Sony MDR-V700. These are a bit expensive, but my one experience with them was very good. The nominal impedance is 24 ohms. Is this a reasonable
/archives//html/TenTec/2008-06/msg00080.html (6,856 bytes)

2. [TenTec] Ten Tec Orion II Beta Testing (score: 1)
Author: bill ogden <billogden@optonline.net>
Date: Sat, 01 Nov 2008 15:22:47 -0400
I hope there is a little more to the update than what is listed in the status description. Like several others, I am considering moving my O1 back to the 1.xxx level. It seems to me that the noise re
/archives//html/TenTec/2008-11/msg00018.html (7,410 bytes)

3. [TenTec] Orion-1 problem (score: 1)
Author: bill ogden <billogden@optonline.net>
Date: Thu, 25 Jun 2009 19:32:58 -0400
The received signal strength on my Orion-1 is way down. The sub receiver is OK. The effect is as if a send/receive relay did not fully revert to receive. I hear a few strong signals, as if they were
/archives//html/TenTec/2009-06/msg00118.html (7,692 bytes)

4. [TenTec] Orion-1 problem (score: 1)
Author: bill ogden <billogden@optonline.net>
Date: Fri, 26 Jun 2009 12:45:01 -0400
I had many suggestions to reseat the cables. I did this, including a slight twist on all the small coax cables on the top chassis, the bottom chassis, and the front panel. Also tried flexing the pane
/archives//html/TenTec/2009-06/msg00122.html (7,797 bytes)

5. [TenTec] Orion-1 problem (score: 1)
Author: bill ogden <billogden@optonline.net>
Date: Sat, 27 Jun 2009 10:27:06 -0400
Based only on a gut feeling, I suspected the problem was in the switching diodes. Several people suggested playing with the noise blanker. SUCCESS. The receiver works if the "hardware" noise blanker
/archives//html/TenTec/2009-06/msg00131.html (8,342 bytes)

6. [TenTec] Original Orion Firmware (score: 1)
Author: bill ogden <billogden@optonline.net>
Date: Tue, 17 Aug 2010 18:06:16 -0400
I am using 2.062a My wish list includes the following: 1. More useful NB and NR, especially for CW 2. More linear adjustment of recorded CW messages as the speed is changed 3. Spread the audio proces
/archives//html/TenTec/2010-08/msg00275.html (10,417 bytes)

Current List: 1 - 6
Page: [1]
This search system is powered by Namazu