Try grounding ground side of speaker to ground from power supply. If hum is still there there is a 4.7 ohm resistor that might be shorted Or a 270 uf cap open both feed the audio amp Byron Cordes ___
The print I looked at had the 4.7 ohm and a 240 uf cap to filter the 12 volt supply to the audio amp. Normally the resistor would open up but it's a chance. A choke would be a better choice but cost
It takes a little time . About 10days for me. No Omni VI CPU Boards available . Hope they can keep going . They did say might have some stuff for sale soon . Maybe hopefully! AC9PA Sent from my iPhon
Yes some parts are hard to get if at all.A lot of problems are caused by bad caps, not hard or costly but very time consuming. Bad connections solder joints again dont cost but time. Shipping can be
Ill buy . PayPal ? Thanks Byron AC9PA Sent from my iPad _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Hi did you get my email about the Omni vi? If not here is my email byroncordes@icloud.com. I would like to but the old radio . AC9PA Byron Cordes _______________________________________________ TenTe
I have had both Orion and Orion II .Had to replace display in the Orion caps in power supply , power cord connection. The Orion II just the caps on the power supply board. Both great radios especiall
You are RETIRED how did you find time to all of this? Hihi AC9PA Sent from my iPad _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.co
I would pay $220 for both Omni s + shipping PayPal Sent from my iPad _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/list