I notice the same on this end....Paragon II, 238B atu and MFJ-259B analyzer. Also, my Mirage MP-2 wattmeters indicate a different power output reading from the rig and atu if other than full power ou
A subnote...if I connect my Mirage MP-1 line sensor directly in back of my Paragon II, then the swr readings on the MP-2 and rig will jive...even on 10 meters. -- Original Message -- From: "Denton" <
Although not specific to TT's, I am wondering if there is a box that allows one to use the same antenna with two different rigs at the same time? and would allow one to transmit on the same antenna w
I am wondering about the fesability of tweeking my Omni VI's rtty, or fsk port for use on psk31. Has anyone done this? I am using the usual soundcard route for that mode presently. __________________
I use something called "Ice" available from bicycle shops. Works very well for the capacitor and roller inductor bearings also. Dig out a lower voltage walwart out of the junk box to use for the ligh
Wonder what code says about installing the power supply at the breaker box and running high voltage lines to the amp in the shack? -- Original Message -- From: "Ed Cummins" <w3etc@comcast.net> To: <t
check relay coils for the bandpass filters...My Pegasus had the same problem on 20 meters....and the relay coils were in series with one another on each side of the bandpass filter. -- Original Messa
Hi all... I recently was given one of those old TT banana mics, and I believe they have a crystal element in them. I am thinking of replacing the element with either a dynamic or a condenser mic... H
Hi all.... I have a Paragon II and an Omni VI, both hooked up to separate TT power supplies. The rigs co exist nicely, but I recently did a bit of horse trading and have a number of sealed commercial
I have posted this thread before...but thought would try again and see if I can come up with any new ideas or info.. Currently, I have a Paragon II and an Omni VI Plus upgraded to option 3 running of
Hi Jerry, thanks for the most informative reply -- Original Message -- From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net> To: <tentec@contesting.com> Sent: Tuesday, January 09, 2007 6:15 PM Su
Wonder what it would take to get my omni vi plus option 3 to do that? Have all filter positions filled with TT filters...but then there's Inrads.... -- Original Message -- From: "Dennis OConnor" <ad4
I had a Corsair II...and I consider the Omni vi to be superior, if I set the incomming signal on 2000 hrz and click in the N1 filter (very high pass) and also use the psb filter and 250 hrz cw filter
I have been running 8-38 amp hour Powersafe (Hawker) gas absorption mat connected in parallel that also have each battery's B+ outlet fused, going to a MFJ power block for distribution to two vhf/uhf
Begs the question....why is the crowbar's clamp typically put across the output of a power supply instead of across the filter cap? The crowbar's sence connection, of course, belongs at the power sup
Check the dc power plug...and the dc B+ path...fuse, wiring, etc..to the finals. -- Original Message -- From: "Peter Hoon" <peter@nednet.net> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.