I just got my Corsair II back from Ten Tec for a PTO rebuild and check up - so I'm sure it works. I never operated the rig before - sent it to Ten Tec as soon as I got it - so I must be missing somet
And the winner is.....The missing plug in jumper between Key and Keyer Out. Looks like the previous owner forgot to include it. I can use a short RCA M-to-M or use the jumper that came out of the VFO
You might consider and old Ten Tec rig if most repairs will be done by you. Any Issue will have already been known, there would be a ready supply of used parts, etc. something like a Paragon or an Om
Ron, So you're the one :) There I was with my little 17W Argo V trying to work this guy in Sweden and all the big guns are masking my signal - 1KW, 700W, 500W minimum, big compression, etc. Finally,
I've been waiting and watching the classifieds lists and missed one by about 10 minutes. So thought I'd inquire here. Anyone have a model 263 (prefer G) VFO that works with Corsair II that they'd lik
Duane, I've been thinking of such a remote idea with the Pegasus. But how do you reconcile the FCC "control of remote enquipment" sections. I though control channels had to be on 440Mhz? Is remote co
Ten Tec'ers- sorry if this is too long. I almost answered direct, but maybe there is someone else out there just ready to try - or at least watch - these digital modes. Ten Tec gear is so great for t
I'll sell my factory assembled Idiom Press CMOS4 for $90 shipped to lower 48. It works just fine, but I've given up on iambic and will build a kit that supports ultimatic mode once I sell the CMOS4 a
You might try the free Commander software as part of the DXLab suite of programs. There are a few reflectors so just put DXLab in google and look around. Also, for a fee, I believe N4PY has rig contr
It might work, it might be junk, but the MFJ-1703 switches two antennas to two rigs. So the Ten Tec is on the Dipole and the Elecraft is on the Vertical. Throw the switch (manual) and the Ten Tec is
You might check with a local library or museum and see if someone there has suggestions. I'm guessing they have some experience with long term paper storage. 73, Paul
Randy, I was once standing were you are rig/computer-wise. You didn't mention what Mac you have so I don't know if it has a serial port - they dropped those a while back in favor of USB. You could ge
I did search the archives but found nothing current about the Pegasus compared to Flex-Radio SDR-1000. Now that the Pegasus has been discontinued, is SDR-1000 the only "living" game in town for SDR?
Anyone have experience with the RX-340 compared to the RX in the Orion with ability to pull the weak ones out, scan for activity, etc. Thanks and 73, Paul
From time to time the display on my Paragon II goes blank (I think the VFO A light is still on). At that time, the audio still works - I can still hear the station I was listening to - but the tuning
Larry, I found it very convenient to have one computer dedicated to ham radio. I shopped online and found a small desktop profile (not standing "tower") compaq with a 300MHz Pentium III with about 12
The SGC-2020ADSP runs 3.5 amps @20Watts so you might be able to dial it back. It is not the best in anything - though the DSP sure quiet's the noise level down - but seems to be good enough for a por
Does the Pegasus have line level in/out and/or a din plug in the back like the Argo V. Line level, rather than mic/speaker I/O is just so convenient for PSK with the one DIN plug interface. Does the