I will say in defense of the NR on v2.031, there is a substantial difference in the noise floor between the settings 1 through 9. The noise almost disappears at 9. However, the artifacts in the recei
It apears that the NR does infact work better in 2.031 based on my comparisons to 2.030. It is much more aggresive. The disortion appears to become a factor only when the RF gain is adjusted to below
Well, I have spent the last 4 hours working with release 2.031 and my impressions are far different of the NR capability than when it first came out. My receive antenna is a rain gutter. The band of
The one used for Yaesu _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Henrick, The answer to your question is yes I do. I have tried to determine a pattern that causes the distortion but this is a hard one. It appears to change per band. The RF gain affects it, the # o
Good feedback Grant. I guess the issue I am observing is that there is a magic spot on signal strength where the signal is above the noise floor but below a certain s-meter reading where distortion b
Henrick, Any chance you have the 600 and 300 hz roofing filters installed? And if so is your filter selection auto? _______________________________________________ TenTec mailing list TenTec@contesti
I think you nailed in Grant. RF gain set to 100. I agree that NR works very well at this setting but as you reduce your RF gain, the NR begins to distort. So, there appears to be a direct relationshi
Toby, Nothing is broke...there are just a few of us who refuse to be appliance operators. It is an excellent radio. Do I find the sweep concerning? No I don't. It's an interrupt thing. It serves my p
Now that was well put! _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Hey Grant...while on the discussion of nits-in-bits, this is what I discovered with CW and the NR. Pretty simple and seems to be a great combo. Be light on the RF gain, like notning below 90... make
I don't know about that Henrick. Unless I am contesting, I leave the 600 and 300 off and use auto. Seems to work pretty well. I thought I was onto something between the roofing filters and the NR but
I happen to like not having memories. And, this has to be one of the best autotuners I have ever used. It tunes when my other rigs and external AT can't. I don't miss the memories at all! ___________
Does the factory tuner tune only the TX or does it tune the RX as well? Thanks Doug / K0ZU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.conte
Phil, Mine did the same. Do a abttery reset, then a master reset...the problem never occured again _______________________________________________ TenTec mailing list TenTec@contesting.com http://lis
I agree with John. It was a hassle at first but now I appreciate the OII internal tuner. All my previous ant tuners never failed to leave the radio in a confused state at some point or another. opini
I am thinking about picking up an up to date omni 6 plus. what's the going rate? Thanks Doug / K0ZU _______________________________________________ TenTec mailing list TenTec@contesting.com http://li
Anyone experiancing issues with mixw and the Orion II performance when servicing interupts and using the cat interface from MixW? The only speed I can get anything to work at is 57600, but at this ba
Thanks carl...I really never got a chance to demo it due to school and work so I guess I will just purchase it. As far as the responce using logic8. Do you really should work for them. Personally, it