John, I use my Omni VI on RTTY all the time. I built the FSK interface shown on AA5AU's website and it works fine. I use MMTTY and N1MM logger for RTTY contesting. I haven't tried any other modes. Do
I have developed a new problem with my Omni 6 Option 3. It is used primarily as radio # 2 in SO2R RTTY. I fired it up this morning following last weekends contests and I am having trouble receiving R
Well, my Omni 6 is in for repair, and Ten Tec has diagnosed a logic board failure. Due to the unavailable chips, this means a dead radio. I know this isn't the first and wont be the last of these gre
Carter, I just didn't want to fill everyones inbox. I'm sure the flames will start flying about Ten Tec's service. Don NT0F -- Original Message -- From: "Carter" <k8vt@ameritech.net> To: "Discussion
Dave, They gave me the option of further troublesooting, for a price. But Paul basicaly said it's a logic board failure that they can't fix. I don't know if the service ticket will have any more info
Dave, I agree with you. I could have insisted they troubleshoot the problem further, but of course that is at my expense, and most likely will have the same end result. I'm going to put it on my benc
The original problem started during to 10 meter contest. All was working OK. I took a short break, and when I came back, the audio was dead on the rig. I cycled power, and at that point, the rig woul
Jerry, Here is what I have found so far. I opened up the rig, verified I was getting 13.6 volts to the logic board on connector 2. When I turned the rig on, the lower section of the display was out,
DW, The 705 should be wired to plug directly into the Omni 6. It uses the pre amp and should obtaing its power from the rig. Don NT0F -- Original Message -- From: "DW Holtman" <tubestuff@comcast.net>
Doug, The 302 remote encoder is great with the internal voice keyer on my Orion. You can program the 3 F keys to send the 3 voice messages. I use it in every SSB contest. Don NT0F Has anyone interfac
Carl, Will this convertor key FSK from MMTTY? Don Steele NT0F Yes, you sure can. These devices give you simultaneous multiple comports that do not interfere with each other. There are a lot of them o
Count me in.I would love to look it over. Don NT0F -- Original Message -- From: <N0KHQ@aol.com> To: <tentec@contesting.com> Sent: Tuesday, April 05, 2005 2:00 PM Subject: [TenTec] New Orion Owners He
Don,I had an Omni 6+ with the 2,8 Inrad filters.I installed the 2.8 in place of the factory 2.4 filters.I then installed 1.8 in both IF's for narrow SSB reception.This leaves your other slots for CW
To the group, I have been using a Heil Pro Set with the Heil mike adaptor(I can't remember the part number)as my only mike since purchasing the Orion.I have never experienced this problem in over 200
Sure,come on down(Southeast Iowa) your welcome to take a look. Don NT0F -- Original Message -- From: "Ron Feutz" <feutz@wctc.net> To: <tentec@contesting.com> Sent: Sunday, December 26, 2004 3:10 PM S
Jim,I replaced my Omni 6+ with an Orion.It's about the same height,but wider and much deeper. 5.25 high 17 wide 18.75 deep. -- Original Message -- From: "Jim Miller WB5OXQ" <wb5oxq@grandecom.net> To: