Remove the meter from the radio (easy). Peel the front cover off (only Scotch tape holds it in place!). With a jewelers screwdriver, turn the pivot tension adjustment screw 1/4 turn CCW. Reverse the
I dont think that is a memory status hashtag. I read the manual pretty thoroughly and did not find a reference to this. Has the radio ALWAYS done this? I believe that the hashtag is the loss-of-lock
H Greetings: I have an Omni 6 that starts boot up, goes through the process of turning the S meter lamps on, then stops with all pushbuttons LEDs lit. I checked the 20 MHz oscillator (good) and I che
The reason I wanted you to do the experiments was to eliminate other routes for coupling of various digital signals into the receiver. Ten Tec had LOTS of problems with this sort of thing. The undesi
In support of your great suggestion, I have myself seen (and forgot to mention) cases in which the ground pins on a TMP connector on a Ten Ten PC board had come loose and thus the cable was not groun
I get your point about my errant use of the term ground in this case. I think what you clarified is what I had intended to say, that a coax with shield not tied to board common on both ends does inde
Is it the same on all bands? When going to TX, do you hear the antenna relay clicking? (Listen very closely as this radios really is very quiet.) I have seen the coils go open on the reed relays TT u
That sounds like the antenna relay. However, those relays often failed anyway. I have a bunch of them from an Omni 5 junker. Can you send me a photo of the one in your radio so i am certain.? Gary
No, because he is seeing full current draw in transmit. The power is being produced by the final amp. just not getting to the antenna jack, signifying a bad d/R relay. Gary
Well, I entered the SDR world with my new IC-7300! Thats off topic but what I have observed with it is very much on topic. Over the past year I have heard, on all rigs, a carrier sweeping across the
Before I post to the worlds largest auction site, I wanted to see if there is any interest here on the reflector for my many Orion parts. I have all boards except CPU. I have VFO encoders. I have a 6
As Ten Tec always said (when they cared) was, Replace all of the capacitors on the A9 power distribution board. That would be a good place to start. Gary