A working one with new dial cord recently sold for $142. The dial cord is not a lot of fun to replace but I have successfully done it. Getting good 0.020 non-stretch spring is the real challenge. Can
For those who keep track of this sort of thing, I had purchased an Omni 6 with what appeared to be a CPU problem (gobbledegook on the display). I was prepared to acquire yet another parts set What ma
If you are off frequency consistently by 100 Hz on all bands, your problem is not likely on the PLL board. A failure on the crystal PLL board would only cause loss-of-lock, and the frequency error wo
I have wondered about this myself. I tried such a setting and the meter did not respond favorably so I went to the more logical value, in the same progression series as all of the other numbers. Gary
Some posting recently have given a Bourns part number for replacement encoders for Orion series radios. These are really good encoders, are a perfect fit, have a nice step feel that stays in position
I have two sets of the VFO "Tires" for Omni 5, Omni 6, Paragon, Orion 1. These include the inner piece that fills the gap between the knob and the outer tire. They are New Old Stock in baggies. $15 p
The DSP would not cause your problem as described. If the DSP were dead, you would get no audio and no noise. First make sure you are not selecting a filter that is not present in the radio. The rese
Well, I sold off all of my Orion small encoders to help others repair their radios. Now I have an Orion 2 with two bad encoders. Does anyone have any or does any one recall the replacement I had hear