The manual does not include alignment instructions for the Omni 6+. I won\der if anyone has a link to that process. I am getting slightly different output power on each band and would like to equaliz
On one band or all bands? Gary W0DVN _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
OK, the fact that it does this on many bands eliminates the various band select relays. Does the Transmit power also become unstable? Gar y _______________________________________________ TenTec mail
Before you put it out to pasture, send it to me and I can have a look at it. Gary W0DVN _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesti
To simulate the heating condition, take the case off and throw a thick towel over the radio. When it acts up, remove the towel and troubleshoot. A can of freeze mist goes a long way here in terms of
The Century 21 uses a 500 KHz wide 1st IF that is produced by heterodyning the desired signal with a crystal oscillator for each band. This 5.0 to 5.5 MHz IF signal is amplified via a broad band IF s
I have for sale an FM board for an Omni 6. It is guaranteed working with its cable. $40 shipped in CONUSA I will NOT sell to the person requesting one for private reasons but still want to sell it. I
I have a parts Paragon if you need anything. All but the synthesizer is good. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.co
I have a Titan II, with a just-completed Russian 4CX1600 tube installation. It generally works, produces significant output. However, even at standby the plate current is about 600 mA and DROPS sligh
I think I still have my logic board. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Oscillator crystal for 40. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
I actually have a fully working board on eBay right now. If its worth $50 shipped to you, I can end that listing and sell to you. _______________________________________________ TenTec mailing list T
Not that I am aware of I dont want to gut a good board for just one crystal. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com
I will pay $350 shipped. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Just letting everyone know I still have a handful of the correct TCXO for the Omni 6 and 6+ so you can retire your dying one heated reference oscillator. $55 cash shipped. Gary ______________________
Its been a long time since the last post (aside from mine) on this reflector Is Ten Tec and interest thereof dead and buried? Gary _______________________________________________ TenTec mailing list
Frozen displat? Does the radio work otherwise? Supply problem is likely the filter cap. If it is not up to par, the voltage to the regulator has insufficient headroom to remain in regulation. Check v
I have maybe 6 of these. All are nice condition. $18 each shipped in CONUSA. Gary Sent from my iPad _______________________________________________ TenTec mailing list TenTec@contesting.com http://li
I have two sets of the original end caps. Both are near-perfect. $0 each pair, shipped in CONUSA. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http:/
Not "$0 each, $40 each pair shipping in CONUSA. Gary _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec