Mail Archive Search: <+from:jim.bell@canada.cdev.com>

Results:

References: [ +from:jim.bell@canada.cdev.com: 6 ]

Total 6 documents matching your query.

1. Argosy Design Problem (score: 1): Author: jim.bell@canada.cdev.com (James Bell); Date: Tue, 02 Jul 96 09:24:34 -700; The following is a design problem on the ARGOSY that only appears after several years. The band switch shaft in the ARGOSY 1 and 2 runs between the heterodyne oscillator crystals. In many cases the s; /archives//html/TenTec/1996-07/msg00003.html (7,026 bytes)
2. ARGOSY &PTO Stability (score: 1): Author: jim.bell@canada.cdev.com (James Bell); Date: Tue, 23 Jul 96 08:40:47 -700; HI Guys, On the Argosy 1 , PTO instability was caused by several factors. When pushing on the top cover close to the front of the set the frequency would move or jump several 100 cycles. The solution; /archives//html/TenTec/1996-07/msg00105.html (8,018 bytes)
3. NOISE BLANKERS (score: 1): Author: jim.bell@canada.cdev.com (James Bell); Date: Tue, 25 Jun 96 10:40:04 -700; A good "noise source" to test the blanker is to connect up a 12 v DC relay with one of its N.C. contacts in series with the supply. The resultant buzzer and spark at the contacts makes a wonderful no; /archives//html/TenTec/1996-06/msg00067.html (6,472 bytes)
4. NOISE BLANKERS (score: 1): Author: jim.bell@canada.cdev.com (James Bell); Date: Fri, 28 Jun 96 08:31:00 -700; Some time ago I used the 12 volt relay simulator to set up the noise blanker in a Kenwood or Yaesu rig. The simulator is supposed to mimic ignition noise. The blanker in the set tuned beautifully and; /archives//html/TenTec/1996-06/msg00096.html (6,689 bytes)
5. RE Scout issues (score: 1): Author: jim.bell@canada.cdev.com (James Bell); Date: Tue, 21 May 96 13:02:22 -700; Frequency jump in the TEN-TEC PTO is not a new thing. The ARGOSY suffered from the same problem. I believe that the grease in the internal screw mechanism would get contaminated with use and RF would; /archives//html/TenTec/1996-05/msg00053.html (7,075 bytes)
6. Argosy VFO Drift (score: 1): Author: jim.bell@canada.cdev.com (James Bell); Date: Mon, 27 May 96 11:31:49 -700; After 30 min warm-up,my current Argosy drifted +500hz in the next 1/2 hr. This positive change indicated an effective decrease in capacitance due to heat build up. The test was done in an remote room; /archives//html/TenTec/1996-05/msg00059.html (7,207 bytes)

Current List: 1 - 6
Page: [1]