Search String: Display: Description: Sort:

Results:

References: [ +from:john@jmp2.wanadoo.co.uk: 11 ]

Total 11 documents matching your query.

1. [TenTec] Orion mic preamp question. (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Wed, 12 Jan 2005 18:52:01 -0000
I wish to use my Yaesu MD-1 dynamic mic with my Orion, however the output at 5mv is too low. The Orion Mic gain needs to be at max 100 to talk about 1 foot from the mic and I like to have some gain i
/archives//html/TenTec/2005-01/msg00398.html (8,259 bytes)

2. [TenTec] Orion mic preamp question. (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Thu, 13 Jan 2005 10:08:44 -0000
Ok Bob W2WG, will do. John / N0KHQ and Joe / K2XX - thanks both for the reminder of the mic preset gain control accessible through a hole on the bottom cover. Apologies, I forgot to mention that I kn
/archives//html/TenTec/2005-01/msg00423.html (7,763 bytes)

3. [TenTec] RE: Orion AUX out audio question (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Sun, 23 Jan 2005 16:21:55 -0000
Can I also echo the wishes of Martin & Bob. ** ** Line Level SHOULD BE FIXED (as per the label) at 0dBm across 600 ohms = 0.775volts, IRRESPECTIVE of the volume controls. ** ** If TenTec see more peo
/archives//html/TenTec/2005-01/msg00911.html (9,020 bytes)

4. [TenTec] Orion mic preamp question (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Sun, 23 Jan 2005 17:18:09 -0000
On Jan 12, I asked if anyone knew the best way to connect up a mic preamp to the Orion. I have now built and tested the preamp with the Yaesu MD-1 dynamic mic and found the following works fine: Mic
/archives//html/TenTec/2005-01/msg00914.html (7,399 bytes)

5. [TenTec] Orion bug report - SubRx sidetone level (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Wed, 2 Feb 2005 13:03:42 -0000
Orion bug report - SubRx sidetone level -- In case anyone else has observed this bug, I have copied this to ditsnbits. Model: TenTec Orion v1.372 Scope: Sub Rx - CW & SSB modes Symptoms: Receive leve
/archives//html/TenTec/2005-02/msg00039.html (6,841 bytes)

6. [TenTec] Orion & Tune button (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Sat, 26 Feb 2005 16:55:07 -0000
My Orion S/N 08C10404 with firmware 1.372 has an internal ATU which I have disabled. On TUNE, it delivers just below 20w (the specified level) if the POWER is set to 20 or higher watts. (If POWER is
/archives//html/TenTec/2005-02/msg00756.html (8,398 bytes)

7. Re: [TenTec] Reflector (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Thu, 3 Mar 2005 13:34:01 -0000
Absolutely agree! May I also echo the request for the moderator to set up another reflector exclusively for ORION topics ONLY ,,,,,PLEASE ? John G3PPB --Original Message-- Message: 10 Date: Wed, 02 M
/archives//html/TenTec/2005-03/msg00103.html (7,745 bytes)

8. Re: [TenTec] Reflector (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Thu, 3 Mar 2005 17:51:45 -0000
Where is it? It's not visible on the front page here... http://lists.contesting.com/ I read the Yahoo Orion565 list on http://groups.yahoo.com/group/orion565/ which has very low posts compared to thi
/archives//html/TenTec/2005-03/msg00117.html (8,525 bytes)

9. Re: [TenTec] Reflector (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Fri, 4 Mar 2005 14:53:30 -0000
OK, we do have a separate Orion list BUT it is hidden! I have asked Eric K3NA who runs it to add it to the front page, hopefully this should stop the periodic requests for an Orion list. Tom, it was
/archives//html/TenTec/2005-03/msg00152.html (8,121 bytes)

10. Re: [TenTec] Reflector (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Fri, 4 Mar 2005 16:57:55 -0000
Thanks Dave - yes this works fine for individual emails, however I (and I suspect many others) like to receive digests which normally contain 12 or more posts in one email. In this case, the filter d
/archives//html/TenTec/2005-03/msg00156.html (9,023 bytes)

11. Re: [TenTec] orion tuning steps (score: 1)
Author: "John Perkins" <john@jmp2.wanadoo.co.uk>
Date: Sun, 27 Mar 2005 15:56:51 +0100
Bill (KC4ATU), you raise a good and valid point. But don't forget that with software control, you can have your cake AND eat it!! I have asked Ten-Tec if we could have AGC decay time right down to 1
/archives//html/TenTec/2005-03/msg00703.html (8,609 bytes)

Current List: 1 - 11
Page: [1]
This search system is powered by Namazu