Mail Archive Search: <+from:johnclif@ix.netcom.com>

Results:

References: [ +from:johnclif@ix.netcom.com: 126 ]

Total 126 documents matching your query.

1. [TenTec] Ten-Tec used/demo list August 5, 2003 (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Tue Aug 5 19:20:22 2003; If the rig is defective, has the complainer sent it back to Ten-Tec for repair? If so, did it work when it came back? Was the radio purchased from Ten-Tec or a third party? If the latter, then if the; /archives//html/TenTec/2003-08/msg00082.html (8,802 bytes)
2. [TenTec] GPS and Ten Tec Rigs (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu Aug 14 21:56:20 2003; Well... the Omni VI/VI+ uses a 10 Mhz master oscillator (either a crystal oven or TXCO, depending on model), so... couldn't you bring in the external 10 Mhz reference signal and use it in place of th; /archives//html/TenTec/2003-08/msg00326.html (8,259 bytes)
3. [TenTec] GPS and Ten Tec Rigs (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Fri Aug 15 03:25:03 2003; Several people have replied that the overall frequency stability of the Omni VI/VI+ depends upon the crystals on the Local Oscillator board. However, according to the circuit description of that boar; /archives//html/TenTec/2003-08/msg00330.html (8,958 bytes)
4. [TenTec] Using WWV to calibrate an Omni VI... one method (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Sun Aug 17 14:21:09 2003; Hello Scott, To verify/check for any soundcard error, you can use the sidetone. It is generated by the DSP and is independent of the TXCO/crystal oven. Just run DigiPan/MixW and verify that the sidet; /archives//html/TenTec/2003-08/msg00371.html (10,654 bytes)
5. [TenTec] GPS and Ten Tec Rigs (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Wed Aug 20 22:19:30 2003; Here's a question... how frequency-stable are the top-of-the-line rigs from other manufacturers? I ask this because I wonder if one would see any practical difference between a rig that was slaved to; /archives//html/TenTec/2003-08/msg00440.html (8,158 bytes)
6. [TenTec] Antenna Analyzers (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu Jul 3 22:44:26 2003; No one has mentioned the AEA analyzers... how 'bout some feedback on them? - jgc John Clifford KD7KGX Heathkit HW-9 WARC/HFT-9/HM-9 Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100 Ten-Tec Omn; /archives//html/TenTec/2003-07/msg00125.html (7,778 bytes)
7. [TenTec] Coax sizes for amp usage... (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu Jul 17 03:49:22 2003; Greetings fellow Ten-Tec'ers... I am in the process of hooking up my Centaur and 238B to my shack. I'm planning on using RG-58 coax in 6' lengths to run my K2 and HW-9, and RG-8M for my Omni VI, to a; /archives//html/TenTec/2003-07/msg00504.html (7,534 bytes)
8. [TenTec] Programming bugs (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Sun Jun 15 08:26:05 2003; Hmmm... I'm running Win 2k Pro and haven't had to reboot in weeks. As a user, I haven't encountered a bug in MS Access, MS Excel, or MS Word in years. I think that most users never run across bugs in; /archives//html/TenTec/2003-06/msg00486.html (12,685 bytes)
9. [TenTec] CW on 60m (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu May 15 03:15:51 2003; Rather than CW, I think that PSK31 or some other digital mode would be a better use of the band than SSB voice. These should make great PSK channels as the sunspot level drops. However, no rig that I; /archives//html/TenTec/2003-05/msg00366.html (9,528 bytes)
10. [TenTec] Re: CW on 60M (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu May 15 18:43:10 2003; I looked thru the FCC regs and discovered that the 'J3E' designator is a requirement for voice and sound (not telegraphy or digital data) transmission exclusively. That is why even though it is possi; /archives//html/TenTec/2003-05/msg00417.html (8,766 bytes)
11. [TenTec] IC-7800 (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Sat May 17 07:41:39 2003; Interesting rig. I will say one thing for Icom... that display sure is nice looking. And it sure presents information clearly. <FLAME PANTS ON> I'm sure I'm going to be attacked en masse... but IMO c; /archives//html/TenTec/2003-05/msg00525.html (11,340 bytes)
12. [TenTec] IC-7800 (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Sun May 18 01:27:55 2003; A thoughtful response... thanks! <sarcasm off> - jgc John Clifford KD7KGX Heathkit HW-9 WARC/HFT-9/HM-9 Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100 Ten-Tec Omni VI/Opt1 Alinco DR-605TQ I; /archives//html/TenTec/2003-05/msg00578.html (7,865 bytes)
13. [TenTec] Omni VI+ s-meter light replacement? (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Tue May 20 04:24:25 2003; I have found that often the bulb has developed some corrosion that causes it to go out. At any rate, you can merely remove the top cover (4 screws) and get to the bulbs. Find the offending bulb and s; /archives//html/TenTec/2003-05/msg00699.html (9,097 bytes)
14. [TenTec] DC Power Supply Backup (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Wed May 21 16:28:52 2003; I had some of the same concerns when I wanted to ensure my shack could stay up and running even if the power went away. Samlux sells a device that is probably meant for the cellular phone industry th; /archives//html/TenTec/2003-05/msg00772.html (9,662 bytes)
15. [TenTec] Display color (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu May 22 15:22:29 2003; Ater looking more closely at the display on the website pics, it appears as if the display is strictly monochrome (black and white, with no grayscale capabilities). Even so, it could look better. Aft; /archives//html/TenTec/2003-05/msg00849.html (7,965 bytes)
16. [TenTec] Eccentric display? (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu May 22 18:43:02 2003; What this signifies to me is perfect attention to detail. It's a pretty good bet that, if that level of attention was paid to the trim screws, the rest of the car would also be of similar quality-of; /archives//html/TenTec/2003-05/msg00861.html (11,083 bytes)
17. [TenTec] Eccentric display? (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Fri May 23 03:28:13 2003; expensive than ANY As in radios, while looks may not be EVERYTHING they are what gets you to try the product out further. I would venture to say that if you dated someone who you generally liked but; /archives//html/TenTec/2003-05/msg00893.html (9,399 bytes)
18. [TenTec] Orion Frequency Accuracy (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Fri May 23 03:32:56 2003; I use a similar technique with my Omni VI/Opt 1 with TXCO, but I use the waterfall display in MixW to ensure that USB and LSB are the same offset from the center freq. After letting the rig warm up f; /archives//html/TenTec/2003-05/msg00894.html (7,251 bytes)
19. [TenTec] FCC Letters for "Enhanced SSB" (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu May 29 01:22:32 2003; I think that getting better sound out of 2.8 kHz or less is an admirable goal, and I understand that some hams have taken the time and effort to determine not only what frequency response will provid; /archives//html/TenTec/2003-05/msg01111.html (8,844 bytes)
20. [TenTec] Omni VI with option 1 versus IC-746 (score: 1): Author: johnclif@ix.netcom.com (John Clifford); Date: Thu May 29 01:28:51 2003; The Omni VI/Option 1, which is effectively a VI+ without the extra 9 MHz filter slot, is a vast improvement over the 746 in receive quality. It is more comparable to the 756 Pro and Pro II. You will; /archives//html/TenTec/2003-05/msg01112.html (8,155 bytes)

Current List: 1 - 20
Page: [1] [2] [3] [4] [5] [6] [7]