Ten Tec #288 Filter 1.8 KHz for sale. $60 mailed USPS. Have a serious need for a Paragon II schematic diagram that shows pcb boards, front and back panel interconnecting wiring. My manual only has sc
Am unable to tune my 135' HB 2" ladder line fed antenna any lower then 5.2 MHz when using a MFJ 259 Analyzer. All frequencies above 5.2 tune fine. The tuners rotary inductor acts like it needs more t
Did Ten Tec make any performance improvements (ie soldered board conections, etc) in the later #586 PLL over the earlier #585 PLL's ? Thank you. joe k7mks
Thanks Gary Joe -- Original Message -- I cant speak insider facts here but I have had many Paragon 2 radios and none of them had PLL issues. Gary _______________________________________________ TenTe
Thank you Bob joe k7mks -- Original Message -- AND they nipped the through hole leads on the parts too short Gary W0DVN _______________________________________________ TenTec mailing list TenTec@cont
Seeking a source of the two black plastic front corner pieces as used on Corsair, Paragon Power supplies and many other Ten Tec items. Thank you. joe k7mks
Which came first the 4-conductor black power cable or the flat 4-conductor ribbon cable? Why the change? Any preference of one over the other? I have a couple of 961s and wonder the best way to pack
Would like to by a good working PLL Major board or send my board for repair to a person familiar with these PLL boards. Is anyone parting or servicing a Paragon? Thanks joe k7mks
Allen: What is Gary's email adr or phone nr. Joie -- Original Message -- Oops. Gary's call sign is W0DVN (not DNV). I'm not really dyslexic...but, confess to carelessness with the keystrokes. Allen--
Bill: I also have a Corsair II. S/N 02519 and would be interested in any comments you may receive regarding your post. Thank you joe k7mks 425.747.5349
I've heard that factory soldering concerns, with PLL boards, may have been satisfactorily addressed somewhere in the 500-600 serial number range. Rumor or fact? S/N involved? Tnx. joe k7mks
Bruce" FYI Joe -- Original Message -- Phil Woods "Bio-Lube" is my go to lubricant for VFO repairs (and others). Amazing stuff. Rich K8UV _______________________________________________ TenTec mailing
I"m enjoying a late S/N (25xx), which is new to me, and am puzzled about the filters. The manual says there is a 2.4 KH filter (which may be a roofing type but was not called that in the 1980s) and m
Brian Check w/ TT I bought some from them a while back for my Paragon Same part. 73 joe 7mks -- Original Message -- I just got my Omni VI back from repair and the USPS didn't treat it so kindly. I am
My recently acquired My recently acquired Corsair II, with DRIVE full CW, delivers 76 watts or so on all bands except 10 and 15 where output is slightly less. Panel meter pegs to the left and regardl
Shawn The ammeter on the Shawn The TT PS reads 13-14 A and the meter on the Corsair pegs to the left when meter switch is at IC. It should swing to the right and read essentially the same as the mete
Ron: I will take it if it is available. I have a 253 coming and may need the cable. PayPal OK? joe k7mks -- Original Message -- I have an interconnect cable for the Omni 5 and 6 series transceivers t