Try a Master Reset. To do this: Turn the Orion off. Then push in and hold the Main RX/TX button upper left; while pushing this button in turn on the Orion. Let go of the Master Reset button (Main RX/
I'm running an Orion II with the LDG antenna tuner built for ORION without any problems, i.e., as described in the manual. Concerning the use of the tuner for the first time or with a new antenna, yo
Bet LDG considered the market for the ORION LDG tuner and took the appropriate action. Ron/NU1U The ongoing discussion of the LDG OT-IIP tuner brings up a question that I've been wanting to ask: does
I have a Heath SB-1000 amplifier, which I use with my Orion II. Being conservative with my radios, The Orion II( actually keys an Ameritron Model ARB-704, which keys the amplifier. It's good knowing
I'm running Color 3 on the Orion II without any flicker (with the backlight set to LOW). With the backlight set HIGH, I still do not see any flicker. Running the latest version of the OII software. I
Goodness, Every one is an expert or not..... The Orion is for hard core contesting or Dx Chasing, especially in crowded band conditions. Take a look at the chart at http://www.sherweng.com/table.html
And........, which includes on two different bands if desired. Ron, NU1U Bob, did you abandon your original question showing interest in radios with computer control? Orion I/II are the only Ten-Tec
I would like to know if TenTec helps you once they know that you installed the LDG OP-11P in the Orion. Also, make sure you have the latest manual from LDG's website. I would check and make sure that
I'm running Dxbase 2007 logging program and Ham Radio Deluxe (latest version) with out any problems on my Orion II (ver 2.037J FW) Ron/NU1U I should have mentioned that I am using a microHAM microKEY
DxBase 2007 works with the Orion I and II very nicely; it's also a great DX logging and report generator program. Ron/NU1U I have a used Orion II that is suppose to be here on Wednesday (from K8OWM)
I've noticed the same issue with my Orion II; great audio with the speaker and not as great with the headphones plugged into the Orion's headphone jack. I solved the problem by plugging my headphone
Hi Jerry, Yes indeed; Six is open and has for bunch of weeks; and I sitting here with 3 HF rigs plus HF power. My buddies up here in Southern New Hampshire are needling me to get on the 'real' Six Me
Not Normal, and it's a symptom of a power supply problem. Had the same problem with mine. The problem was the power supply; that is, did not have the capacity to handle the Orion in the CW mode. The
I owned the Orion I with the built in LDG tuner, and now own an Orion II with the LDG model OT-11P tuner. After engaging the tuner (e.g., the tuner is active) and then changing bands, the Orion (both
Yep, I can reliably reproduce this on my Orion II with version 2.030 software The Orion II is set up in the following manner: 1 frequency 14201.00 2. Initial setting is in USB 3. Internal Tuner engag
Along with AM, Spark and DOS, so will SSB and CW go by the wayside. Just digital and FM will probably remain. 73's Ron, NU1U Grant, I look at it as some people insist on still running DOS programs wh
The following Ten-Tec Filters are for sale: (9 MHz I-F Filters. NAR position bandwidth filters for Omni-V, Omni-VI and VI Plus transceivers. Used as roofing filters for ORION). - Model 219 250 Hz, 6
To All, The subject filters have been sold; thank you for every one that responded. Ron, NU1U The following Ten-Tec Filters are for sale: (9 MHz I-F Filters. NAR position bandwidth filters for Omni-V
I installed the LDG OT-11P tuner into my Orion II last week. Other than their version 1 instructions wasn't modified for the Orion II, I did not have any real issues installing the device. The deltas