Good evening, I have the following Ten-Tec accessories for sale. These are in good to very good cosmetic condition and are in very good electronic condition. I do accept PayPal. I will only ship to t
Hi, Dave, Thanks for the response. This is certainly confusing. The Model 263 VFO I advertised has the same biege case as the Corsair II and the same brown "face" as the front trim on the Corsair II.
Hi, Ron, Thanks for your comments. I talked to Ten-Tec this morning. You are correct that the two VFOs are electrically the same. I asked them about why mine looked like a cross between the 263 and 2
Hi, Mike, I am certainly interested in the transverter Jack, KE4ID have an assembled Ten Tec 1208 6m transverter that I'll give away. I acquired this unit from Ken, N9VV, and when I used it a couple
Hi, Steve, I have a Corsair and did a couple of things of things to lessen the noise and make the rig more sensitive. -I put a low noise broad band bipolar amp between the 9 mHz filter output and the
Hi, Gang, I suspect that the reason that some are not bothered by strong signals inside the roofing filter is that the AGC kicks in and knocks the signals down enough so that the interfering signal d
Good morning. George, thanks for your comments about removing the source bypass resistor (I should have said CAPACITOR) from the 1st IF JFET amp in my RX-320 to cut down the front end gain. A resisti
I have used the attenuator approach, but it DEGRADES the noise figure or minimum discernible signal of the receiver. In some cases the use of the attenuator is just fine. I am using 36 db of outboard
Estate sale: Ten Tec Omni C, remote VFO, Power Supply with built-in speaker. Narrow SSB filter and CW filters included. VFO needs restringing. Good condition with some scratches/paint chips. WARC ban