I suppose i could ask Ten Tec this but does anyone know when or if they put the TCXO in the OMNIVI+(564)? John N1JM _______________________________________________ TenTec mailing list TenTec@contest
I have exausted all possibilities trying to find a replacement encoder or the complete for an Omni 6 Plus. Any one out there have a spare encoder in their junk box? _________________________________
I finally located a Centaur (buying a used one directly from Ten-Tec) to add to my station (so I can find a new home for my FL-2100B). I am sure that there are no issues interfacing the Centaur to my
Larry: A few months ago I was about to do the same thing. you are currently considering. I had found a Delta II used that looked in fine condition. So I contacted Ten-Tec engineers to talk about the
From my experience running PSK there are a few issues to consider: Audio to mic or audio in on rig (you can use either) must be clean, undistorted, without hum, or rf feedback artifacts. - Try to kee
A technique often used is to cut the blown track away just at the points where it is still valid. Remove any resist from the last 1/4 inch or so of remaining trace. Drill wire guage holes at the end
Yesterday a ham friend of mine reminded me that I had some time in the past mentioned seeing an article on modifying a D-104 for use on lower-impendance mic input rigs... and that he wondered if I re
Parting with my trusty Omni-C Station to pick up a local bargain on a Paragon Station. Package Price Only (I am not a Weasel). Please don't ask for separate items! Ten-Tec Omni C with 1.8 and 500 hz
I just added a really mint Paragon to my station. It has all filters, FM board, Speech board and the Gheil chip too. Unfortunately it does not have the serial interface which would be of great use. S
Paul: PTO's incorporate temperature compensating components that theoretically cancel the drift changes of other components.... bringing relative stability. Trouble is they are never perfect and they
Well now that I have a Paragon in my Ten-Tec station (Along with an Omni-6+, 229B, two Scouts, a 526 and an RX-350) I have been trying to ferret out the lineage of the 'Giehl Chip'. My Paragon (built
To Vic, Jim and all who have replied! Thanks for your time and your info. This has been an interesting quest for information. Sometimes a bit confusing. However, yesterday my search really paid off a
Heh, I know finding an RS-232 interface board for my Paragon is gonna take some time. I may actually have to wait for a 'Weasel' to appear... or was it a 'Ferret'? Hopefully, someone will just redisc
In preparation for the time when I may need to make some alignment touchups (frequency readout accuracy, etc). I'd like to locate alignment instructions. My Ten-Tec manual is very comprehensive as fa
If you are working from the version 2.6 standard install you do not have most of the rig control features available. Especially for the Omni- VI (which I use). All these advanced features are in his
It is 5am and I am not able to sleep so you are all in for it! :( I recently did a bit of revamping of my shack placing two more HF rigs on line with my Omni-6+ (I also have two Scouts but they are a
[I'm about to step into it big time] I'm really NOT going to weigh in on the Orion issue. First of all I don't own one, although I have been considering obtaining one for the future. I do, however, h