Gang, Have not had this rig on either of these two bands for some time and decided to give them a try today. Much to my dismay, I found that I am not transmitting on either band. The rig works on all
All, I will also post this to the Jupiter group, but seems I have no power output on 10 meters. I can see amps being pulled on the power supply when the key is brought up or mike button pressed, but
Rick and Bill, Thanks for the quick response. Shortly after I posted the question, I also tried 12 meters and found it too had no transmit, but okay receive. I'll take a look at your web page Rick an
All, A few days ago, I foolishly allowed an auto-tuner attempt to match an end fed wire connected to my Pegasus. I am the original owner of this radio and it was the third Pegasus sold by Ten Tec. A
Thank you Chuck. I'll start looking for them this evening. I'll go through the archive also. Karl - W5QJ 73 Chuck -- Chuck Till K4RGN@ARRL.NET Raleigh, Wake County, North Carolina, 27613, USA (FM0
All, I have a Corsair II that I picked up at a hamfest that needs a bit of TLC. Somewhere along the line, the ALC pot was cross-threaded when it was installed in the front panel. The pot works for a
All, I bought a FTDI 25 pin serial cable for my Omni VI Plus and am interested in what others may have used or are using for CAT control. Flrig, both the Windows and Linux flavors, will allow frequen
First, thank you all for your help. I had to use a FTDI cable as the PC the Omni VI is connected to has three serial ports in the expansion slots and doesn't have room for a fourth. I played with thi
All, As I suspected, a reboot of the PC resulted in the same problem I had with flrig initially (very sluggish T/R sequencing and sometimes a program hang leaving the Omni in transmit). Perhaps if I
I've been through three online transistor cross references without luck. I am looking for a small NPN that would cross to this: Original transistor: BC407B Material of Transistor: Si Pol
Hello Mike, I could use it if you still have it. Please let me know. Karl - W5QJ On 8/14/2021 3:14 PM, Michael Tortorella via TenTec wrote: Found an extra one: Key to Keyer Out jumper for Corsair II
Thanks for letting me know Mike. Karl Hello Mike, I could use it if you still have it. Please let me know. Karl - W5QJ On 8/14/2021 3:14 PM, Michael Tortorella via TenTec wrote: Found an extra one: