I have TT Model 5024 power divider.. It is rated for 900 - 1500. I am not sure what the purpose of this divice. What is the value it in x lent condion.. Any offers? Larry N5BEA
I did the opposite.. Back In about 1980. I went to An FCC office and chunked My Novice Ticket I had clunkers like some sort of Heiliscrater Transmitter etc. After a lot 2 meter work and a ham fest or
I want it... Did You get my previous email? _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
I tried to put a very nice Argosy on the air but... When I gave it power there went the breaker. I metered it to find a dead short accross the DC input.. Anything I should know? Are there any inherie
I am looking for a mic.. If I can't locate one, I will just have to order a new mic from Ten Tec. Even though old this is my main station rig.. It is mint ... Right now it's at the factory getting th
Hello... first the obvious a power transformer.. Data stream? A cable transponder-leak sometimes cable co.s provide internet access. Otherwise- Are you rural or urban? Is the noise constant or pulsat
Over the years I have been involved in curing things causing QRM -mostly public utilities. Advice: if you locacte the problem emphisise the terrible noise in things like radios tvs and phones.. Don't
I am trying to put a value on a just about mint 540 and 252 power supply. I also have TT keyers and a Mint Ten Tec Ant Tuner. Currently the radio is at The Ten Tec Factory. It is getting a good going
I am trying to put a value on a just about mint 540 and 252 power supply. I also have TT keyers and a Mint Ten Tec Ant Tuner. Currently the radio is at The Ten Tec Factory. It is getting a good going
Hello... I am Larry N5BEA (licensed in about ' 79) I have been off the air for a while.. So Now I am trying come back and specializing with a vintange station. Mostly low power DX. I am 100% Ten Tec.
This will the first one on my 3 recently acquired TenTecs to go on the air... I just wonder if there are any particular things that I should know that is not in the manual... I have been reading a lo