Looking for an INRAD 762 600 Hz. roofing filter. Please reply off the list with asking price. Lou, WØFK Lladerman <at> earthlink.net _______________________________________________ TenTec mail
My SP is working, I can definitely hear added compression when it is turned on. However, as reported by W4CAK, there is little if any difference between setting 1 or 9. I also noticed a loss of audio
See http://users.vnet.net/btippett/inrad_.htm Lou, W0FK _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Just installed v2.055. Can't give much of a report yet other than that the speech processor now works well. Increasing the setting actually increases the compression level. I could tell no difference
I installed v2.055 yesterday. Operating ssb this afternoon, after a time received signals in the main receiver became distorted (sounded like they were clipping) and had discernable "clicks." In addi
That must have been it. I turned on the automatic notch and recreated the "problem." Oh well, I'm still on the learning curve. Lou, W0FK I have seen this in CW when the automatic notch is on. It is o
I installed v1.373b3 to check out, and have run into something unusual (to me in any event). When I move the BW encoder, "DSP T/O" appears on the display in the "send 2" area, continuing to the right
Yes, I did. I also reloaded the software in case something didn't transfer properly the first time. Lou, W0FK Did you do a master reset after installing the firmware? You don't indicate. Larry, N0XB
Jack, I visited the rfsquared website this morning, and it lists the most recent firmware updates as of 3/10, not 4/1. The current versions listed are v2.032 for the Orion II, and v2.056 for the Orio
It's an April Fool's joke. Caught me before I had had my morning allotment of caffeine. Lou It MUST be April 1st.... I can't believe it.... Jack, I visited the rfsquared website this morning, and it
I'm interested in trading an INRAD 754 (2800 Hz 9001.5 center freq roofing filter) for an INRAD 756 (2400 Hz 9001.5 center freq roofing filter) for the Orion I. Please reply of the list. 73, Lou, W&O
I installed the LDG OP-11P tuner in my Orion I today. The tuner and transmitter work great, but now I am hearing no signals through the main receiver; the sub receiver is working well. DSP seems to w
All is now well. I opened the radio again and pulled the face plate. One of the cables going to a circuit board inside the face plate assembly was disconnected. It must have worked loose when I was r
I'm interested in either (1) trading my INRAD 754 (2800 Hz 9001.5 center freq roofing filter) for your INRAD 756 (2400 Hz 9001.5 center freq roofing filter) for the Orion I, or (2) selling the INRAD