Search String: Display: Description: Sort:

Results:

References: [ +from:mike.hyder.n4nt@charter.net: 49 ]

Total 49 documents matching your query.

41. Re: [TenTec] Hissness (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Thu, 12 May 2005 16:44:42 -0400
When I turn down the RF gain on my Corsair II (if memory serves), the noise almost vanishes. I get further reduction of hiss using the Autek QF-1A you got for me at Dayton, Steve, thanks again. Mike
/archives//html/TenTec/2005-05/msg00207.html (10,798 bytes)

42. Re: [TenTec] OMNI C PTO Rebuild (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Fri, 20 May 2005 19:48:00 -0400
There's a trick to getting the PTO out of the Omni-D. Here's what Ten-Tec advises: -- PTO REMOVAL AND REPLACEMENT FOR OMNI MODELS 545 AND 546. 1- Remove top, bottom and front panel as per pages 3-1 a
/archives//html/TenTec/2005-05/msg00337.html (8,347 bytes)

43. Re: [TenTec] Birdie on 20 Meters Ten Tec Corsair II (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Mon, 30 May 2005 08:36:29 -0400
Do you hear it both with an antenna connected and without an antenna? Have you found any signal weaker than the birdies? 73, Mike N4NT I have noticed a birdie on 20 meters on the frequencies of 14.22
/archives//html/TenTec/2005-05/msg00595.html (8,052 bytes)

44. Re: [TenTec] 962 Power Supply Shutdown; RFI Cure? (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Mon, 6 Jun 2005 07:10:05 -0400
I had a similar problem with a 544 Triton. The trouble was the diodes used to develop ALC voltage were bad. This allowed the PA to oscillate when the drive control was advanced beyond a point. 73, Mi
/archives//html/TenTec/2005-06/msg00203.html (8,178 bytes)

45. [TenTec] Centurion loading (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Mon, 20 Jun 2005 17:44:04 -0400
I'm new to this Centurion thing and have a couple of questions: My loading control does not seem to have much effect on 80 meters. I believe the amplifier acts as if it does not have sufficient load
/archives//html/TenTec/2005-06/msg00489.html (7,310 bytes)

46. Re: [TenTec] Centurion loading (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Mon, 20 Jun 2005 20:12:55 -0400
I am running the amp on 230 VAC. I would think my antenna impedance is close to 50 ohms as I am using a Drake MN-2000 tuner and adjusting my W5GI mystery antenna for almost no reflected power. Based
/archives//html/TenTec/2005-06/msg00502.html (10,179 bytes)

47. [TenTec] Centurion Loading (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Tue, 21 Jun 2005 11:07:53 -0400
Many thanks to all those who took the time to respond to my inquiries about my Centurion. I spoke with John Maples at Ten-Tec Service this morning and he wants to look at the thing -- says it doesn't
/archives//html/TenTec/2005-06/msg00523.html (7,983 bytes)

48. [TenTec] Gripes about the Orion (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Thu, 23 Jun 2005 11:41:09 -0400
If one has a problem with the way his Orion works, then here are my suggestions: 1. a. Describe the difficulty as precisely as possible. b. What were you doing when it occurred? c. Is it repeatable?
/archives//html/TenTec/2005-06/msg00628.html (7,361 bytes)

49. Re: [TenTec] re should i buy an orion now (score: 1)
Author: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Date: Fri, 24 Jun 2005 18:22:18 -0400
or carl rove And if you DO like it, and say so, you'll be compared to a Nazi. -W4SK _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.c
/archives//html/TenTec/2005-06/msg00670.html (10,480 bytes)

Current List: 41 - 49
Page: [1] [2] [3]
This search system is powered by Namazu