Mail Archive Search: <+from:mike

Results:

References: [ +from:mike_n4nt@charter.net: 284 ]

Total 284 documents matching your query.

21. Re: [TenTec] omni v short dits (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Sun, 25 Jul 2004 12:32:54 -0400; Hi, Tom-- I've been reading this thread somewhat puzzled. The problem may be terminology. Here's what I think these folks are trying to say: 1. When the key closes, it brings the key line in the rig; /archives//html/TenTec/2004-07/msg00790.html (23,722 bytes)
22. Re: [TenTec] Amp and 580 (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Mon, 26 Jul 2004 12:47:01 -0400; Hi, David-- The N/O contacts that can be used to energize an amplifier relay are available in the 9-pin (or so) Molex connector on the rear panel. What I've always done was to jumper this to one of t; /archives//html/TenTec/2004-07/msg00849.html (7,349 bytes)
23. Re: [TenTec] Corsair Model 561 PTO (incl. caution about petroleumlubricants) (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Mon, 26 Jul 2004 14:01:00 -0400; Hi, Mike-- What you describe sounds precisely like my experiences with all Ten-Tec PTO's when the grease inside them has become old, sticky and gummy. The solution is to remove and disassemble the PT; /archives//html/TenTec/2004-07/msg00855.html (9,900 bytes)
24. Re: [TenTec] 243VFO Crystals (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Tue, 27 Jul 2004 19:50:59 -0400; Anyone have a source for Ten-Tec 243 VFO crystals?Thanks. Joe K4XZ JOE PATRICK SENIOR PLUMBING/MECHANICAL INSPECTOR CITY OF BOYNTON BEACH _______________________________________________ TenTec mailin; /archives//html/TenTec/2004-07/msg00891.html (7,652 bytes)
25. Re: [TenTec] 243VFO Crystals NEVER MIND (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Tue, 27 Jul 2004 19:56:38 -0400; qsl.net seems to be working again. the vfo is for the omni, I see. Anyone have a source for Ten-Tec 243 VFO crystals?Thanks. Joe K4XZ JOE PATRICK SENIOR PLUMBING/MECHANICAL INSPECTOR CITY OF BOYNTON; /archives//html/TenTec/2004-07/msg00892.html (7,854 bytes)
26. Re: [TenTec] omni d problem (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Fri, 30 Jul 2004 22:33:21 -0400; The place to start is to remove the circuit boards, one at a time, and reseat them. If you have any DeOxit you can use on their pins, do so. Removing one board at a time will keep you from mixing the; /archives//html/TenTec/2004-07/msg00959.html (8,455 bytes)
27. Re: [TenTec] Basic question - Long (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Sun, 1 Aug 2004 17:57:56 -0400; You know, it troubles me when folks take any opportunity to take cheap shots at anyone. Why don't you folks carry your ill will elsewhere and not bother the Ten-Tec reflector with it? Mike N4NT Bill,; /archives//html/TenTec/2004-08/msg00024.html (10,683 bytes)
28. Re: [TenTec] Tennessee Dreamin' (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Mon, 2 Aug 2004 19:47:08 -0400; Since we measure signal strength in volts and power in watts and since watts vary with the square of the voltage, are your 6dB per S-unit dB of voltage difference or of power difference? In other wor; /archives//html/TenTec/2004-08/msg00085.html (9,099 bytes)
29. Re: [TenTec] Tennessee Dreamin' (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Mon, 2 Aug 2004 21:53:53 -0400; Maybe if you rewrite your response it'll make more sense to me. As it is, my mind doesn't follow your logic. By the way, where did you hook your meter to measure free space's impedance as 377 ohms? I; /archives//html/TenTec/2004-08/msg00092.html (10,776 bytes)
30. Re: [TenTec] Tennessee Dreamin' (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Mon, 2 Aug 2004 23:27:50 -0400; I suppose what I found confusing was any reference to impedance as it would seem to remain constant during our doubling of power. The aerials would be constant, the ether, too. So whatever the impeda; /archives//html/TenTec/2004-08/msg00096.html (14,127 bytes)
31. Re: [TenTec] Tennessee Dreamin' (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Tue, 3 Aug 2004 01:41:58 -0400; Thanks, Ken-- This one I understand. Thank you for your patience and your explanation. 73, Mike N4NT watts Mike, If the impedance remains the same doubling voltage quadruples power. Either way it is; /archives//html/TenTec/2004-08/msg00103.html (10,990 bytes)
32. Re: [TenTec] Tennessee Dreamin' (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Tue, 3 Aug 2004 10:35:24 -0400; Well excuuuuuuuuuuuuuuuuuse me! Mike N4NT You need to study the basic stuff in the ARRL Handbook, just like the rest of us did when we started out. Jim Duffer gave you a very good explanation. You do; /archives//html/TenTec/2004-08/msg00108.html (9,852 bytes)
33. [TenTec] Your semi-annual Astron tip... (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Wed, 4 Aug 2004 15:10:14 -0400; [TenTec] Your semi-annual Astron tip... People come and go from this reflector. This is a reminder that many troubles with Astron power supplies can be cured by grounding the negative post to the cab; /archives//html/TenTec/2004-08/msg00181.html (8,154 bytes)
34. Re: [TenTec] Filter on the Roof (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Thu, 5 Aug 2004 10:45:33 -0400; What's a BDR? Well Buck, I guess you could just fiddle around with it until the BDR degrades then you'll know you have the filter in-line. Isn't it amazing what we've come too? Rigs are now so comple; /archives//html/TenTec/2004-08/msg00221.html (10,092 bytes)
35. [TenTec] Losing the music - an apropos story (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Thu, 5 Aug 2004 13:11:16 -0400; Once there was a young man in medical school. He knew that his father struggled every day to pay for the son's education. Fondly he would think of his father's coming home from the plant each day and; /archives//html/TenTec/2004-08/msg00232.html (8,052 bytes)
36. Re: [TenTec] Tennessee Dreamin' (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Thu, 5 Aug 2004 17:32:19 -0400; A patient, kind fellow said that it really doesn't matter, just the formula differs for dB change in voltage and power. As I understand it from what he said a 3 dB increase in transmitter power will; /archives//html/TenTec/2004-08/msg00239.html (9,389 bytes)
37. Re: [TenTec] Argo V users?? (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Mon, 9 Aug 2004 20:59:43 -0400; What's your power supply? To anyone with an Argo V..... Have you gotten the transmit audio to sound ok? Before I bought mine, I saw a lot of negative input regarding the transmit quality on eham. Sur; /archives//html/TenTec/2004-08/msg00382.html (7,955 bytes)
38. Re: [TenTec] 100 w. mobile rig (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Sat, 14 Aug 2004 09:29:25 -0400; Probably has to do with safety. If you get distracted with a transmitter (i.e. cellphone) and crash in a Prius, you're probably as dead as the bugs on the windshield. Mike N4NT I couldn't resist comm; /archives//html/TenTec/2004-08/msg00610.html (9,674 bytes)
39. Re: [TenTec] cw cd (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Sat, 14 Aug 2004 15:55:35 -0400; Getcha a Buckeye aerial. Skip may be in for Ohio. Mike N4NT The reason I can't listen comfortably to cw in the truck on my 706 is that there must be something wrong with my tarheel antenna I can't se; /archives//html/TenTec/2004-08/msg00642.html (9,045 bytes)
40. Re: [TenTec] Ten Tec Support (score: 1): Author: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>; Date: Sat, 14 Aug 2004 18:12:33 -0400; That calls for a country ham at Christmas... Mike About a week ago my beloved 10 year old Omni VI developed a problem. I called the Ten Tec service dept and described the problem. The tech told me wh; /archives//html/TenTec/2004-08/msg00649.html (7,099 bytes)

Current List: 21 - 40
Page: [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15]