Hello. Yes, Ive have this same action when the sweep terminates. I believe it to be that the RF level is not reset to the value it had before the sweep began. I wrote to them about it 8 or 9 years ag
Hello. Im currently using a 100 A PowerMax with no issues. The power supply fans is noisy when it does come on though. Cant you wire up an overload voltage circuit for it? Fernando N2FQ/6 n2fq@sbcglo
Hello. I too have the noise and contemplating replacing mine with a Noctua. My internet reads say they are very quiet. Some chatter on the IC-7300 group with its fan noise, the proponents also say go
Well.. the old display was easy to remove without removing the front panel. Four nuts and two cable assemblies. So far so good. Was able to remove the bezel by straightening the holding tabs. Wow.. t
Oh.. forgot to mention that on mine the LCD Reverse menu item is ineffective. No matter how high/low I make the contrast, the ON/OFF of this menu item does nothing. Fernando N2FQ/6 n2fq@sbcglobal.net
Do you happen to recall the specifics? Here is the one Im eluding to on eBay: Yeah.. I know kind of small, cut and paste. 162294417788 Do you still have the old one? Like to tinker with it. Fernando
Not to monopolize the thread, here is what I found in my Jupiter. The voltage regulator supplies 5V to parallel resistors, then 4.5v to J12. When I put 5V directly to J12, the backlight brittens up a
Well, received the display from China today and surprised it arrived so quickly. Looks identical with the exception of the lack of cabling. From the looks of it, changing the LEDs on the old one enta
FWIW.. My numbers are on the far right column. Using the TenTec dummy load and reading the watt meter on my Palstar AT1KM tuner: 1.900 Mhz 110 Watts 110 3.750 Mhz 120 Watts 110 7.150 Mhz 110 Watts 10
Sad news. One way to find a replacement is to get any info from the one in the radio. A search on the parts list yielded this: encoder hrpg A google search shows than Mouser has one for $32. A pruden
Thank you so much for the update Ripley. Sounds like youve done an extraordinary amount of troubleshooting. Kudos to you. Are you able to use the rig in Pegasus Emulation Mode? Something of the likes
Hello. Im leaning to the power pole replacement. Mine has it since 2010 without a hitch. Not too difficult to do. With the pigtail soldered to the board, I would be afraid that something could drop o