I have a Ten Tec Corsair with a display issue... all the digits work but on some bands the mHz section reads off freq. while the kHz section reads accurately, radio other wise in very good condition,
I'm in search of a broken, partially working but complete Corsair. Please email me with details and price at n2wjw@yahoo.com thanks. Sent from my iPhone
Is it me or does it seems the Argo V has way too much gain? I know I can press the attenuator but that reduces the gain a bit too much and I would like to find a happy medium. Is there a way of g
Just got a used Corsair and the AGC does not come on when the switch is either on slow or fast, it acts as if it were off on all three positions. I have checked the boards for any indications of a ba
The Corsair used an AF/AGC or audio derived AGC according to some of the readings I've done and owning Corsairs in the past I still thought there was a problem till today when I turned the radio on,
Spent a little more time with the Corsair today and noticed an intermittent AGC and found some components with loose soldering joints in the IF AF board, re-soldered them, got some deOxit for the con
Thanks to all the people here for helping me with the AGC problem, now that I got that working, thought I leave the best for last. The frequency display's mhz digits are off on most bands, for exa
I keep getting advice on checking the "jumper" right behind the enclosed PTO, I have not seen a jumper and it is not mentioned in the manual, could someone let me know what to look for? Gil
Somehow I misunderstood and thought the jumper was inside the radio by the PTO. The VFO jumper in the back of the radio is there, I actually took it out and dabbed it with deoxit beore I put it back
Recently acquired a Corsair, works well but the sidetone thump kind of bugs me a little, I did the sidetone mods as per Ten Tec wiki and it sounds better but there is still a thump that increases as
My Triton IV has what looks like a goldish yellow finish on the face and bottom cover ... no its not tar or a smokers rig, this is actually the finish on this rig s/n 01140. It could be that the ty
Installed the 217 cw filter in my Corsair 1 but when switched to the filter position the gain drops considerably and there is white noise, I also tried a different 217 and the same thing lots of whit
The PBT does not work when in the narrow position. The signal is always there from one end of the PBT to the other, in other words....it does not affect the signal at all. Like I mentioned before,
Im in search of a TT QRP rig like an Argonaut (509, 515 etc) or an Argosy. I dont care much about condition as long as its all complete. Please email me with details to n2wjw@yahoo.com Thanks!
My 509 makes a "pop" everytime I key either a dot or a dash and it happens only with an electronic keyer and not with a key or a bug and the pop happens with any electronic keyer I have tried. Is t
A fellow ham dropped me an email with a fix for the keying "pop" which I must say I had my doubts till I actually tried it and worked, very simple fix and below is a portion of his email on the fix,