It's tough to fix. One time I cured this by grounding the PC to the Rig with some braid. RF chokes clamped to the ac cord sometimes help. My final solution was to replace the tube monitor with an LCD
The most common reason for people selling them is because the PTO is giving them trouble and needs rebuilding. Of course you will get the usual, "worked last time I used it" etc. Just count on doing
I had two Omni 6 (plain) and now have the TS-2000. To answer your questions: 1. The TS-2000 because A. Audio is much better for voice modes. Up to 5khz bandwidth can be selected. With a big speaker o
I"ve wondered the same thing Steve but I believe their method outlined in the manual was intended to compensate for variations in filters. It reminds me of the old tube type receivers such as the HQ-
Since you already have some fine equipment, the Pro II will at least give you a new display to play with. Steve N4LQ Hi guys, I wonder if I can get some important feedback from some knowledgeable ham
Doesn't the 6+ use some power to keep the tcxo warm even when off? I think you are supposed to maintain DC on that rig to avoid warm up drift. Steve N4LQ
Mark: If you think it's really some kind of spur, try using another transmitter in your shack to generate the 1.818khz carrier to verify it's really the Pegasus. If it still shows up, try some other
I've seen similar post about the IC-756 pro being overdriven by strong signals. The general cure seems to be the same, reduce the signal level by turning off the pre-amp or adding attenuation or redu
-- StripMime Report -- processed MIME parts -- multipart/alternative text/html audio/x-wav application/octet-stream -- StripMime Errors -- A message with no text/plain section was received. The entir
Speaking of SGC's 2002. Last night I had a CW QSO with a fellow who was operating one from batteries. He had 3 carriers, one big and 2 weak ones about 300khz above and below his main carrier. He put
All the early TenTecs had audio derived agc from the Triton to the Corsair II. It began as a cheap way of obtaining selectivity without the use of of expensive crystal filters. A narrow audio filter
Thanks for the informative review. I was looking at the picture of the Argo V, rear view....Is the coax antenna jack really stuck on there like that or was that just a prototype? Steve N4LQ have Hz m
My other rigs all have the so-239 flange on the inside of the radio, not on the outside. I just checked my Delta and Omni-C to make sure. No big deal. Just looks odd. Steve N4LQ